answersLogoWhite

0

What cabling is capable of 100 Mb s?

User Avatar

FishDoom

Lvl 1
15y ago
Updated: 8/18/2019

cat5

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Basic rate bluetooth is capable of transferring data at what bit rate?

1 mb/s


How much is 100431 KB in MB?

Hi, It,s 100 MB


What is identified by the 100 in the 100BASE-TX standard?

the maximum bandwidth in Mb/s


The speed that shielded twisted pair transmit data at?

Category 5 ( CAT5 ) cable can transmit up to 100 Mb/s


Name a disk system that supports 100 MB per s or greater data transfer rates?

Pretty much any SATA drive will support 150+ MB per second.


How many MB in fast Ethernet?

Fast Ethernet operates at a speed of 100 megabits per second (Mbps). To convert this to megabytes (MB), you divide by 8 (since there are 8 bits in a byte), resulting in a maximum throughput of 12.5 megabytes per second (MB/s).


What is the speed of ide drive?

IDE drives commonly use the ATA standard. ATA usually runs at ATA-33, ATA-66, ATA-100, and ATA-133. These run at 33 MB/s, 66 MB/s, 100 MB/s, and 133 MB/s respectively. Most modern IDE hard drives run at ATA-100 or ATA-133 while older If you have your hard drive on a 40-wire PATA cable and/or the PATA cable attached to your hard drive is also attached to your CD-ROM drive, your hard drive might be forced to run at ATA-33. For best performance, only use an 80-wire PATA cable and do not connect your optical drive with it.


Does a SCSI have the fastest throughput?

It used to, but no longer. These days, for individual harddrives, SATAII and SATAIII (SATA3) are significantly better in performance. However in terms of total throughput performance, SCSI can outperform even SATAII. Here's a breakdown of common interfaces and their bandwidth: ATA/100 (IDE): 100 MB/s Ultra ATA/133 (IDE): 133 MB/s SATA: 150 MB/s SATAII: 300 MB/s SATAIII: 600 MB/s Ultra3 SCSI: 160 MB/s Ultra-320 SCSI: 320 MB/s Ultra-640 SCSI: 640 MB/s SAS (Serially Attached SCSI): 300 MB/s USB1.0: 1.5 MB/s USB2.0: 60 MB/s Firewire: 50 MB/s Firewire800: 400 MB/s 100mbit Ethernet: 12.5 MB/s Gigabit ethernet: 125 MB/s Average Cable Internet: 1 MB/s It should be noted, however, that the world's fastest harddrives do not max out most of these interfaces. An Atlas 3k (15,000 RPM) drive uses SAS, Ultra-320 and Ultra-640 interfaces, but tops out at 145 MB/s average with 202 MB/s peak. As such, whether to use SCSI or SATA is of no importance to standard users. Only servers and mainframes typically need to worry. That, combined with the MUCH higher cost of SCSI drives and SCSI interface cards (and cables) has left SCSI unpopular and largely obsolete.


Is a PCI express 16 bus or the latest AGP bus faster?

PCI x16 's bandwith far exceeds that of all other current expansion slots on home PC's. In other words make sure all your add-on cards are of this type if you motherboard can handle it. The Following table should give a good measurement of where we are at:Common Buses and their Max Bandwidth PCI 132 MB/s AGP 8X 2,100 MB/s PCI Express 1x 250 [500]* MB/s PCI Express 2x 500 [1000]* MB/s PCI Express 4x 1000 [2000]* MB/s PCI Express 8x 2000 [4000]* MB/s PCI Express 16x 4000 [8000]* MB/s PCI Express 32x 8000 [16000]* MB/s IDE (ATA100) 100 MB/s IDE (ATA133) 133 MB/s SATA 150 MB/s Gigabit Ethernet 125 MB/s IEEE1394B [Firewire] 100 MB/s* Note - Since PCI Express is a serial based technology, data can be sent over the bus in two directions at once. Normal PCI is Parallel, and as such all data goes in one direction around the loop. Each 1x lane in PCI Express can transmit in both directions at once. In the table the first number is the bandwidth in one direction and the second number is the combined bandwidth in both directions. Also please note that in PCI Express bandwidth is not shared the same way as in PCI, so there is less congestion on the bus.


How long does it take to download 10000GB on a 100Mb line?

To calculate the time it takes to download 10,000 GB on a 100 Mb line, first convert the download speed to gigabytes per second: 100 Mb equals 12.5 MB (megabytes) per second, or approximately 0.0125 GB per second. Therefore, downloading 10,000 GB would take about 10,000 GB ÷ 0.0125 GB/s = 800,000 seconds, which is roughly 9.26 days.


What is 3 MB down and 1 MB up talking about internet speed?

3 mb/s download transfer to your system1 mb/s upload transfer from your systemmb/s = million bits per second


What is the fastest wireless n card for hp?

any wireless N card is going to operate at the same speed.802.11a = 54 Mb/s @ 5 GHz802.11b = 11 Mb/s @ 2.4 MHz802.11g = 54 Mb/s @ 2.4 MHz802.11n = 600 Mb/s @ 5GHz OR 2.4 MHz