answersLogoWhite

0

All the steel parts can be sold as scrap metal (it gets melted and used again in cast iron). Then of course all plastic too. So, basically the whole lawnmower!

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What do you do to reycle?

we reycle because its good for the envoriment by olly aged 9


Can you charge a lawnmower battery with your car?

Most lawnmower batteries will be badly abused by this and it will be quite expensive in gasoline. A lawnmower battery will normally take 8 hrs (or so) to charge. Forcing them to charge faster, like off your car, will harm it.


How do you clean air filter on my weed eater lawnmower?

Take the air filter off and clean it then put it back


How do you change oil on lawnmower?

Depending on what lawnmower you have just simply take the spark plug out and tilt lawnmoer


What is on or off on a lawnmower switch that has just symbols?

i wish i knew


What is more effiecient a gas or electric lawnmower?

I think a electric lawnmower would be cheaper because current usage goes off the amount of amps and if you have a lawnmower that has a low voltage then it would cost you less.


How do you get a lawnmower motor off?

unnderneath the lawnmower there should be 4 main bolts near each corner of the motor theese need to come out


Craftsman lawnmower only one year old and the rope to start the lawnmower has tighten up and I can't pull it to get it started what can I d?

You might have a problem with the fly-wheel brake if it has one. Take the shroud off the top of the motor and check the cable to the brake if it is OK you already have the cover off so the recoil will be off too, check it and see if it is bound on something.


When I tried to start my lawnmower and pulled the cord it didnt grab anything what can I do?

take it off, youtube has instructional videos for this. hard to tell you exactly what bolts to remove.


How do you Jack up a lawnmower?

you take a jack and jack it up.


How do you take the rear wheel off of a Honda hr214 lawnmower?

jack it up, remove the wheel nuts or if none a carter key under a rubber cap on axel,


How do you replace a drive cable on a Troy Bilt self propelled lawnmower?

To replace a drive cable on a Troy Bilt self propelled lawnmower, first make sure that the lawnmower is turned off. Then, locate the drive cable and remove it according to manufacturer instructions.