0
Add guide fins to the body of the rocket.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Is there a difference between a rocket and a missile?
missile is also a rocket but the difference is that, it hold explosive for mass destruction. a rocket is just use to propelling vehicle like in satellites etc. missiles are self guided by the help of inertial navigation system.
What is the best design for bottle rocket fins?
For a typical water rocket, it doesn't matter much. Three squares or triangles, about four to ten square inches in size, 120 degrees apart, as far below the center of mass (balance point) as you can put them, will do well enough. Use any stiff plastic and a lot of duct tape. Try to glue them on as close to vertical as you can - or if you want the rocket to spin, try tilting them all the same way a couple degrees. (A small amount of spin may help stability; a lot will cut down your altitude greatly). A water rocket isn't going to be very stable at the best of times, since the water tends to slosh around, and the fins can't do much about that. (A little bubble bath in the water, shaken up to get some foam, may help.) yah but whatever else u wnt man(:
What kinds of tasks get done with the help of a lever?
lifting heavy objects
What kind of work is done in a support center?
A support center typically is there to help you with whatever assistance you need. Whether it be technical help, billing inquiries, or general information, a support center is there to help you.
How can you made your own homemade Thermometer?
To make your own homemade thermometer, a person will need a plastic bottle, a clear straw, some putty, water, rubbing alcohol, and food coloring. Fill a quater of the bottle with equal parts water and rubbing alcohol. Add a few drops of food coloring to help see the change in temperature. Place the straw in the bottle and seal the top completely with the putty, making sure the bottom of the straw does not touch the bottom of the bottle. The liquid will rise and fall through the straw when the temperature changes.
What helps the rocket go straight?
The fins at the base of the rocket help it to fly straight.
Why do you use fins and cone for a bottle rocket?
You use fins and a nose cone on a bottle rocket because the cone reduces the drag on the rocket, and the fins help stabilize the rocket.
Would having more fins on a bottle rocket be better?
Fins are used to help keep a rocket stable. The only way to find out if more fins will make it more stable is by testing it.
What parts of a rocket help stabilize the rocket?
fin and tip (cone).
How does gravity help in rocket landing on moon?
There is no gravity in space, therefore there is no gravity to help a rocket landing on the moon.
Golo Is Locked In A Cave Help him to move out?
Fill Bottle 7 . . . then use bottle 7 to fill bottle 5 . . Empty bottle 5 and put the remaining two litres from bottle 7 into bottle 5 . . Fill bottle 7 then use bottle 7 to fill bottle 5 . . empty bottle 5 . . Fill bottle 5 with the remaining 4 litres in bottle 7 . . fill bottle 7 and then use bottle 7 to fill bottle 5 . . this will leave you with 6 litres in bottle 7 . . Done
How does a rocket get out of earths orbit?
surely a rocket or artificial satellite can get out with help of escape velocity....
What Are Forces Involved in Launching A rocket?
Thrust, gravity and upthrust help launch a rocket.
What do rocket do?
Rocket scientists work for space agencies such as NASA. They also help to develop new rocket powered weapons for the military.
How does a rocket help in space exploration?
your mommma
What is the best way to make a bottle rocket?
(First you need some way to put lots of compressed air into the bottle. If you're doing this) well where is the rest of the answer then? what you need to do then is make a proper flight panning system by choosing the design of the rocket you are going to propel. like say put cardboard wings on the side and a paper cone on the tip of the soda bottle, also dont forget you also need to put water in the bottle to launch it properly. then from there you must do a stability text by putting a piece of string and duct tape it to the middle of the bottle to make sure it is balanced if it is not tipping to one side and balanced, then you are ready for the next step, then you spin it around over your head as if you are using a lasso, then from there if it goes in a straight circle and does not move around from side to side you have a stable bottle rocket ready to launch!Note: There are comments associated with this question. See the Discuss:How_to_make_a_soda_bottle_rocketto add to the conversation.What he said.Read more: How_to_make_a_soda_bottle_rocket
Can you help me decide on a name for my webkinz Reno or Rocket?
If the animal is very fast, you should name it rocket.
