0
What can cause a 98 Camaro 3.8 to stall unexpectedly while driving sometimes it could be 5 minutes or even two weeks before it stalls again I've had the ignition control module replaced twice?
Wiki User
∙ 14y ago
crank sensor is getting hot/ bad crank sensor
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What if your 86 bronco ll will not start evn though you have replaced the battery and ignition coil?
it could be the control module
If a 305 engine will sometimes fire and sometimes not could it be the computer or spark control?
Need more info Model Year Carb TBI or MPI ignition type if altered
Is an ECM and ignition switch the same part difference on a jeep wrangler 1990 2.5?
No! The ECM is the Electronic Control Module (Computer), sometimes called ECU, Electronic Control Unit. The ignition switch is just that, the switch that controls the engine ignition, the power to the starter, starting and shutting the engine off, and power to the accessories.
Why would a 1989 Chevy Celebrity 2.8 crank go about 3 miles and then not crank again just turn over replaced the cranksensor relay switch but still nothing and replaced the fuses.?
Check the ignition control module.
How do you change the Ignition Control Module in a 1995 Blazer S-10?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
Why does your 84 z die when accelerating Ignition coil has been replaced fuel pressure is good Is there a sensor doing this?
You have an ignition Control Module that you can check that controls ignition timing Throttle Position Sensor that tells the computer where the throttle is so it can regulate and give the correct air fuel ratio.
Where is the ignition control module on a 1997 Sonata?
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Where is the location of the ignition control module on a Ford Focus?
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
1986 grand marquis has power to the coil but no fire from the coil to the plugs the coil has been replaced and still nothing what else would be wrong?
Replace the ignition control module
Where is the ignition control module on a 1992 Crown Vic?
Where is the ignition control module located in my 1992 Crown Victoria
Where is the ignition control module in a 1997 mercury villager?
The ignition control module sit directly below the distributor.
90 olds mod 98 always starts cold but after it gets warmed up and you turn it o MOST of the time it will not start for about 30 min?
have your ignition control module tested.(heat test) sometimes when the ignition control module goes bad , no starting/hard starting when vehicle is hot is a common symptom.follow up questionwhich is more likely the ignition control module or crank shaft rotation sensor and why?
