Not applying a film of oil to the gasket before installation. Grit or dirt on the gasket or mounting surface. Over-tightening the filter. Only tighten 3/4 turn after making contact with the mounting surface.
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
When you replace your oil filter it come with a new gasket. Just make sure when you remove / replace the old oil filter the oil gasket comes out with it.
Hmm, water in the oil filter does indicate a problem. Head gasket possibly.
The oil filter gasket is built into the filter itself, so just by changing the filter, you always get the new gasket.
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
Oil coming from the oil filter area usually means that the gasket for the oil filter is not seating right. If the filter was changed recently, the old gasket could have been left on, along with the new gasket, causing a bad seal.
if I understand your ? can not changing an old oil filter gasket casue damage to your engine NO only if it leaked out all the oil other wise no. If the filter change was the cause of the leak and you lost enough oil for the engine to start clattering, yes, it caused the permanent engine damage.
Gasket should be included with new oil filter
The oil filter gasket is a rubber ring that is usually bonded to the oil filter. If the oil filter has been removed and has no gasket, then it has become stuck to the engine block. Remove the gasket from the block before installing a new oil filter with it's own new gasket. Be sure to spread a little clean engine oil on the rubber gasket before installation to help seal and prevent sticking to the block. Do not overtighten the filter, turn the filter until the gasket contacts the block and then tighten 1/4 turn more. If the gasket leaks, tighten just enough to stop the leak.
On the filter. The open end that you screw on has a gasket around the outer edge. Oil the gasket before installing.
Here are a few reasons for oil to spray from the filter area:The gasket from the old filter was stuck on the oil filter housing and was not removed before the new filter was installed.The new filters gasket is not seated correctly on the oil filter housing.No Oil filter gasket was installed with the new oil filter.Defective Oil Filter and/or Gasket.Oil Filter Housing came lose from the engine block or mounting surface.
Oil filter installed incorrectly as in too tight, too loose, the gasket was not oiled prior to installation, or the old filter gasket was left on. It can also be a valve cover gasket leaking and running down by the filter. Replace the oil filter and oil the gasket and tighten 3/4 turn after it makes contact with the mounting surface. If the leak persists if is not the filter.