An on / off switch , fuel pump inertia switch , bad fuse etc
A switch is a make - break device. Its function is a circuit is to make and break the current flow of the circuit that it is in. This action then starts and stops the load that is connected in the circuit.
no
make sure there is not a slight break in the circuit
A switch is used to make or break an electrical circuit.
A switch is used to make or break an electrical circuit.
Wire in a turn signal flasher in series with the circuit you wish to flash. The flasher has two terminals. Just insert the flasher anywhere in the circuit. It will make/break the circuit to make the lights flash. This is considering that the circuit is 12 volts and not 120 volts.
we can make an open circuit by disconnecting the wire or break the circuit and a closed circuit is made by connecting all wires with the contents of the circuits.
A break in an electric circuit is called an open circuit. Electric current will not flow through an open circuit.
If the break is in either the feeder or return line, the circuit will become open and the circuit will cease to function.
In a parallel circuit (with more than one branch), the current will still flow in the other circuit(s) even if there is a break in one circuit. This is not so with a series circuit, since it does not have branches: if there is a break in the circuit, there is a break in the circuit.
No, an electrical approved switch is used to break an electrical circuit.
A break in the wires of an electric current will break or cut the circuit and stop the current from flowing.