answersLogoWhite

0


Best Answer

place fuse back in and press and hold unlock button until alarm stops

User Avatar

Wiki User

โˆ™ 2009-08-03 01:29:05
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What can you do if alarm stays on and you have to remove the fuse in order for vehicle to start and at night dash panel is not on or horn does not work?
Write your answer...
Submit
Related questions

What if the anti-theft makes your 97 Pontiac sunfire not crank sometimesWhyAnd how do you fix it?

If an alarm system will not allow a vehicle to start the kill-switch is engaging. The brain of the alarm will need to be disarmed in order for the vehicle to start.


How do you turn off the alarm on a 2005 Honda Accord?

In order to disable the alarm system on a 2005 Honda Accord, you can either disconnect the battery, or remove the alarm module all together inside the car.


Must you remove lug bolts in order to remove the wheel covers?

It depends on the vehicle, some yes, some no.


When jump starting a vehicle once the stalled vehicle is successfully started remove the cables in the same order in which they were connected?

false


How do you remove a persons belongings from apartment if they have a no contact order against them?

steal them at night


How do you remove front calipers from a 2003 falcon?

In order to remove the front calipers from a 2003 Falcon check the vehicle owner's manual. The manual should be able to assist in any removals or repairs that the vehicle should need.


How many screws to remove from caliper in order to change brakes?

Normally 2 but it depends on the make vehicle.


Remove a dash from a 1997 Mercury Sable?

In order to remove a dash from any vehicle you will need to do one of two things. First, take it to the dealer to get it removed or look at the manual instructions to see if they explain how to remove it or if you can remove the dash.


How do you remove a Toyota Highlander 2nd row seat?

Do you want to REMOVE it entirely from the vehicle, or are you asking how to lay it down flat in order to make a longer rear deck floor?


I can I stop the alarm from going off?

You have to program the alarm in order to get it to stop going off by either doing it yourself or by giving whoever is coming into your house the code. You can also contact the alarm company in order to get it to stop ringing.


What do you need in order to install an aftermarket alarm system to Jeep Grand Cherokee?

the aftermarket alarm kit


How do you a change tire?

Park vehicle on level ground Block the wheel opposite the one you are changing Set parking brake Jack vehicle at approved support points just to the level where the weight is off the tire, but tire is still on the ground Loosen but do not remove lug nuts Raise vehicle so wheel is off the ground Remove lug nuts Remove tire Install in reverse order


Can a judge order you to remove your soon to be ex-wife as a cosigner in divorce court if the title is in your name?

Yes. The judge can order the spouse who is keeping the vehicle to refinance it in their name only.


Can a repo company break into your garage to repossess your vehicle in the middle of the night?

No. The repossession agency/agent can obtain a replevin order to be served on the person to whom the vehicle is registered and if said person(s) do not comply they can be held in contempt of a court order.


How do you replace a front tire in a Honda civic 1991?

Place jack under vehicle lift only enough to take pressure off tire Loosen but do not remove lug nuts Lift vehicle so that tire is off ground Remove lug nuts Remove tire and wheel Re-install in reverse order


How do you remove a fuel pump in 2001 camaro?

Unless there is an access panel above the fuel pump, in the vehicle, you must remove the fuel tank in order to gain access to the fuel pump for replacement.


How do you remove a fuel pump on a 2002 Chevrolet suburban?

Unless there is an access panel above the fuel pump inside the vehicle, you must remove the fuel tank in order to replace the fuel pump.


Do you have to remove the power steering pulley in order to remove the bracket on a 93 Chevrolet pickup with a 350 Does the pulley have a bolt in the center?

power steering pulley is pressed on. to remove pulley, u need to completely remove pump from vehicle and take it to a mechanic that has right tools for removing


What are some job requirements in order to be an alarm technician?

To be an alarm tech, you must know various amounts of social sciences, as well as engineering. These are crucial to be a well renowned alarm technician.


How do you take off the top of the fuel tank to get to the fuel pump of a 1999 ford expedition?

You do not remove the top of the tank as the tank is one piece. You remove the fuel tank from the vehicle in order to access the fuel pump.


How do you replace calipers?

Jack vehicle up and support Remove wheels Remove caliper mounting bolts (2) Slide caliper off rotor Remove flexible brake line Install in reverse order Brake lines and caliper MUST be bled (remove air) prior to driving vehicle


Sleep Safe and Sound with an Alarm System?

In order to sleep well at night and feel safe in your home, it may be a good idea to purchase some form of safety alarm system. ADT alarm systems are very common and work well whether you're in the home, or on a trip. Alarms often scare burglars away. Set up the alarm system and help will be on their way if someone breaks into your home. With a quick set up, you will have a code that can turn the alarm on or off. There are even different settings for when you're alseep or when you're away.


Do you have to remove the gas tank in order to replace the canister vent shut valve?

Absolutely not. It's located on the left side of the vehicle near the front tire.


How do you replace the fuel pump in a 2001 Chevy truck?

the fuel pump is in the gas tank. you will either have to lower the tank or remove the bed from the vehicle in order to access it.


If you accidentally turn your vehicle off while still in gear how do you get it out in order to start again?

grasp the shifter, remove from gear (or place in park)... problem solved