0
What can you do if your 1992 Toyota pickup ignition key is stuck in the locked position?
Wiki User
∙ 17y ago
I have a 98 corrolla it gets stuck also . I have found that if you keep turning the wheel left and right while turning the ignition key , the key is locking and unlocking the wheel while trying to turn the key . It will loosen after a while . Also put some spray lubricant in the key hole .
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What is the ignition timing for 1991 Toyota pickup?
wich engine do you have?
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
Does a 1989 Toyota pickup have a crankshaft position sensor?
Yes
Does a cigarette lighter for a 1990 Toyota pickup work with the ignition key off?
no it has to be on accessories or on
What is the ignition timing for 1984 Toyota Pickup?
Should be 8 to 10 degrees before TDC
Why does your 89 Toyota pickup not have spark at distributor?
Check the pickup inside the distributor and see if its OK. Do you have spark at the ignition coil? Check the wires. Or the cap and rotor assy.
Will a transmission from a 1993 Toyota pickup fit in a 1994 pickup?
A transmission from a 1993 Toyota pickup will fit into a 1994 Toyota pickup. The Toyota transmission will not fit in to other makes and models of pickups.
Why won't my brand new starter on my 1998 Chevy pickup disengage after starting and continues to run after ignition turned off?
your ignition switch is hanging up in the crank position.
How does the switching work on a stock Fender Stratocaster?
Position 1. Bridge Pickup, Position 2. Bridge and Middle Pickup, Position 3. Middle Pickup, Position 4. Middle and Neck Pickup, Position 5. Neck Pickup
Will a Toyota 22R motor for a 85 Toyota pickup fit into a 81 Toyota pickup?
if you use the computer if the 85 is efi
How do you put your 1994 Toyota pickup in 4wd?
Should be like the 95. The shifter need only be moved into the correct position to go into 4 wheel. The pickup should have locking hubs so you dont need to get out. If not then move to each front wheel and turn the dial until it points to locked. Then shift the lever in the pickup to 4 wheel high or low. Also look on the passenger visor. It usually has the directions also.
Who designed the Toyota Pickup?
Toyota of the U.S.
