0
What can you do to fix a 96 ford explorer vent that only blows air on high?
Wiki User
∙ 16y ago
what you only need to replace is the blower motor speed controller or also kown as a blower motor resistor.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
I have a 94 ford explorer but just recently the heat stopped working and only blows out cold air. every once in a while it will turn on but only for a couple seconds. what could be the problemHELP?
The heater is blowing out cold air only
Are people reporting problems with the ford explorer climate control?
i have a problem with the automatic climate control the fan has only high speed
Why does my 1998 ford pickup blows only cold air when heater is on?
Because it's broken.
Will front grill and bumper parts from a 97 Ford truck fit a 98 Ford explorer?
Only if the 97 truck you are talking about is a Ranger. Then yes, it will fit the Explorer.
1999 ford explorer no low beams and only high beams when the switch is held back?
Yes. That is by design. Pulling back on the switch is used for 'flash to pass'.
My 94 Ford Explorer will only drive after putting it in drive and letting it warm up what's wrong?
Your Ford Explorer will only drive after putting it in drive and letting it warm up because it has a mechanical problem.
If the fan only blows on high on a 2002 jeep liberty is the relay switch bad or is it the fan motor?
If the fan only blows on high in the Liberty, check the blower resister. The resister circuit is the most likely cause.
What are the choices of engine sizes in a 1992 Ford Explorer 4 wheel drive?
Up until the 1995 Ford Explorer the only engine was the 4.0 L - OHV - V6
What is the cause of a 98 Ford Windstar overheating but heater only blows cold air?
thermostat stuck
Will 22 inch rims fit on a 2010 ford explorer?
Only if your black
How do you fix the blower on your 1991 ford explorer so the ac blows cold air?
The blower is common to hot and cold air. If it is only cold air that is a problem, then the problem is not the blower motor. The blower motor is actually in the engine compartment, passenger side at the firewall.
When turning on head lights in my 1993 ford explorer they do not work when you hold the high beam switch then the head lights work?
your bulbs are burnt out. when you switch on the high beams its only the high beams. but when you flash your brights it lights up both high and low beams.
