0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the use of 7 and 4 pin in IC741?
power supplies +5v and -5v will be given to 7 and 4 pins respectively,therefore it is used for giving power suppply to ic 741
What is cut off voltage of jfet if its pinch off voltage is 5v?
5v
What is the transitive voltage for the voltage input of a CMOS operating from 10V supply?
5V
Which regulator ics are used to get 5v and -5v supply?
Some simple 3 terminal single chip linear regulators are:+5V - 7805, LM309, LM323-5V - 7905, LM320Some high efficiency single chip switching regulators are: +5V - LM2574-5.0, LT1076-5-5V - LT3015-5Note: always read the datasheet carefully to make sure a part meets the requirements of your application before designing around the part.
How do you find the value of a zener diode?
It is depend on your requirement .suppose you need a voltage regulator of 5V than you need 5V Zener diode.
What voltage does a potential relay operate from?
The voltage for a potential relay will depend on the circuit that the relay is installed in. The relay can be made for low voltages (5v) to higher voltages (440.)
Can you use 5V 1A power supply on 5V 750mA?
Yes.
What batteries does scooter robot 2000 use?
5v's
Is it safe to use a 5v 1200ma router power adapter instead 9v 600ma adapter the original one for a longer period because everything works fine for now?
no .never
Where is the Acura Integra cooling fan switch?
it is not connected to a "switch," but a relay instead....it should be grounded to the core support next to the fan.....you may need to remove the passenger side headlight to get to it.....there is normally 1 or 2 wires coming from it....12V and switch signal from ECU (0V = off and 5V = on). To test the fan: disconnect the relay and connect directly to battery. To test relay: use external battery source like 3 AA in series. If you have no clue what I am talking about, then do not attempt this and seek professional help.
What if your power supply for your emach desktop has a bad -5v the other voltages are ok will it damage your computer if you use it anyway -5v line goes to the main board?
Yes
How can you convert plus 5v to 5v?
By changing the polarity of the source
How you can convert plus 5v to -5v?
By changing the polarity of the source
8 plus 5v-7 simplifying?
The answer is 1 + 5v.
What is the use of 7 and 4 pin in IC741?
power supplies +5v and -5v will be given to 7 and 4 pins respectively,therefore it is used for giving power suppply to ic 741
What is 5(v-30)?
35
Can 5v 1amp charger charge a 5v 2amp battery?
yes
