Fat Dictionaries!!!
You probably have the kind that clamps down on the edge of the carpet. It started out as a V. the bottom part is nailed down, the edge of the carpet is inserted and the top half clamped down to hold it. There are hooks on the bottom half that grab the carpet. To remove it, pry up the top half, hold back the carpet and pull up the strip.
you hold down the down arrow key and the way your supposed to go
In the industry, a carpet nail could be one of three things. #1 A reference to the tacks that used to be used to hold down carpet on a wood floor prior to tackless strip ( the 1" wide pieces of wood with pins on it around your walls). Or #2 A nail to hold down those 1" pieces of wood. Or #3 One of the sharp pins in the 1" pieces of tackless strip that hold the carpet onto the tackstrip. There is also a reference to " stay nails " in the industry. These are 1" concrete nails that are driven into the carpet to aid in the installation process and then removed when the installation is complete.
First you have to remove the passenger side seat. Then remove the hold down screws and molding that is along the door sill holding down the carpet. Then very carefully lift up the carpet and the air bag sensor should be there. Then remove the three screws that hold the sensor in and unplug it.
Hold down the * key when you are in the text area.
To install a carpet you would need to make sure you have the proper equipment. You will need a tape measure, seam tape to connect multiple pieces of carpet together, a putty knife to push the carpet under the baseboards of a room (if it has baseboards), a power stretcher to ensure your carpet remains tight and does not wrinkle, a carpet pad and glue to keep the carpet off your floor directly and make it feel softer, carpet cutters to trim away excess carpet and a tack strip around the perimeter of your ROM to hold the carpet down.
Two bolts on the front corners of the bottom half of the seat, hold it down. The top half is held down by two bolts that are under the bottom half.
Answer:It's located on the front passenger cowl/floorboard, behind a panel, under the carpet. Remove the passenger kick panel, sill cover, and peel back the carpet. Remove the 10mm bolts that hold the cover down, remove the 10mm bolts that hold the computer to the backside of the panel.
Berber carpet should hold up for at least 7 years. Make sure you have it installed properly. If you do this, it should last a lifetime. Good luck!!
its on the passenger side firewall. pull back the carpet and with the ignition on, hold the switch down for 3-5 seconds.
The 12 x 20 foot room has an area of 240 square feet, and the 15 x 15 foot room has an area of 225 square feet. That's 465 square feet of carpet. But hold the phone. Carpet is generally sold by the square yard, and a square yard is 9 square feet (as 3 feet x 3 feet is 9 square feet). The 465 square feet of floor is 51.666... or 52 square yards of carpet. It might be necessary to buy some "extra" area depending on the width of the "stock" roll of carpet from which the desired pattern/color of carpet is going to be cut.
The popular idiom "hold the fort" or "hold down the fort" means to watch, manage, or protect an area while the speaker making the request is away.