it would be caused by getting water in the engine make sure your radiator has fluid/water . If it doesn't then your water pump is bad. Which means your getting water in the engine...
It does not have a crank case sensor.It does not have a crank case sensor.
Blow by is caused when combustion gases get past the piston into the crank case. The cause will be piston, rings, or cylinder wall.
Blow by is caused when combustion gases get past the piston into the crank case. The cause will be piston, rings, or cylinder wall.
on top of the crank case towards the outside , it vents into the carb by vacume.
replaced crank case valve location at valve cover
There is no oil in the crank case,,you use mixed gas and oil that's what lubes the crank bearings and piston rings.
as the pistons go up and down, and the temperature changes the air in a crank case has to go somewhere. that is what the vent is for
it means u have water infiltration.either through the cooling system(but i believe these are air cooled)or through rain or going through high water. drain and refill with fresh oil and see if it does it again
Have u had a go at derestricting the restricter in the crank case ? All you do is take off the crank case and there should be a flywheel on the left u undo that flywheel and there should be a washer or spacer take that out and refit your flywheel and crank case making sure everything is tight :)
The starter is located under the engine, right alongside the crank case. As you look to the front of the car, it's on the left side of the crank case.
Gravity. From the Milky Way in this case.
The Milky Way has a diameter of about 100,000 light-years. (If you want to convert that to meters, you can multiply it with 1016 - that is close enough in this case.)