0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is no 1 cylinder on Mitsubishi pajero 6g74 engine?
When looking at engine from front of vehicle it is first cylinder on left bank, cheers.
Where can i find Mitsubishi pajero engine diagram?
1999 NL 3500 6G74 SOHC Engine diagram, Especially the front timing covers section.
Will a jdm Mitsubishi 6g74 motor mount to American 1995 3000gt sl?
Yes. It's basically a straightforward swap for a non-turbo. Would suggest an upgraded (Walbro 255) fuel pump. http://www.3si.org/forum/f35/my-6g74-3-5l-swap-webpage-240131/
What engines will fit in a 1994 diamante?
The only engines that will fit in this car without significant modification to the car are the stock engine (6g72) or the Mitsubishi 3.5L 6g74.
Is it possible to swap the magna tr 4cylinder 2.6ltr stock engine with a 6G74 DOHC I was informed it is a bigger and stronger engine and is it worth it for about 2000 dollars to swap them?
It is possible to swap the engines, and the V6 gives a noticeable improvement over power and acceleration. Just make sure the transmission can handle the V6 or swap the transmission as necessary.
Where is the cam position sensor located on a 94 3000gt?
If you are looking at the engine bay from the front of the vehicle, it will be on the right-hand side, under the timing belt covers (must be removed), on the bottom side of the engine (must remove front driver tire to get at it with ease). It looks like a 3 point "ninja star". Included link to diagram: {http://www.3si.org/forum/f1/6g72-6g74-engine-diagram-measurements-440490/} (I own a 95 3kgt)
Can a 6 cylinder Mitsubishi eclipse motor fit in a eagle talon?
The 6g72 (3.0L v6) can be found in 3rd gen eclipse, Dodge mini vans, 3000gt's among a few other cars. You can also use any 6g block like a 6g74 from a galant or so on... but the one to go with would be your 3000gt engine from 94+ due to the block revisions and aftermarket support.. The answer if it can fit is yes... Do you want to? probably not.. Reasons being this. Engine mounts will have to be custom fit to your sub frame and side mounts for the engine.. you will have to source a 5Speed awd from a non turbo jdm GTO because the gear box is the same as the dsm, and it uses the same drive line after the bell housing basically.. easiest wire up will be stand alone OEM ecu and harness conversion.. Not easy unless you get a donar 3000gt for both, engine, and electrical due to the 3000gt's having like 4 different wire harness set ups and they came in 2 sections and several ecu's.... on top of all that.... only the non turbo block fits into the car easily.. you can do a supercharged turbo block or a remote turbo... But dont plan on fitting a turbo engine into a talon oh and it will be alot easier to do it to a 1g dsm vs a 2g... ALSO keep in mind that you will be doing the usual conversion stuff like power steering, ac, oil cooler lines, fuel lines, coolant lines.. the ups are the 6g72 dohc is built to be mod'd just like a 4g63 by design.. and the 94+ blocks use a nice main cap girdle to add durability to your bottom end... but really.... With all that customizing... id just as soon custom adapt a twin scroll 16g off an evo 8...
