If you are looking at the engine bay from the front of the vehicle, it will be on the right-hand side, under the timing belt covers (must be removed), on the bottom side of the engine (must remove front driver tire to get at it with ease). It looks like a 3 point "ninja star".
Included link to diagram: {http://www.3si.org/forum/f1/6g72-6g74-engine-diagram-measurements-440490/}
(I own a 95 3kgt)
Cam position is taken from the distributor on this vehicle, there is no separate cam sensor.
Where is can position sensor located on 1998chevy 3.1engine
The cam sensor is inside the distributor.
Cam position is taken from the distributor. There is no separate cam sensor.
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
84 does not use a cam sensor. it does however use acrankshaft position sensor located in the lower front section of the engine assembly.
well were is it
located inside the distributor
It is located in the distributor unit.
1991 to 1993 3000gt do not have a crank sensor. Only a cam sensor. And when does go out the car will not start or have a very irregular idle.