Best Answer

Fuel injection or fuel contaminated?

User Avatar

Wiki User

โˆ™ 2011-04-10 01:17:49
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What causes a car to idle fine but dies when put in gear?
Write your answer...
Still have questions?
magnify glass
Related questions

Why does your motorcycle idle fine but bog out when in gear?

Your motorcycle might idle fine and bog out when in gear because of a problem with the carburetor or the bowl. If either area is dirty, it will often bog the bike when in gear.

Very rough idle when dropped into gear on your 99 Chevy Tracker with the 2.0 engine runs fine otherwise have replaced the PCV and plugs no help?

you need the fast idle adjusted on the engine you may have idle set where it sounds fine in idle but not high enuff when dropped in gear.

I have a 95 Mitsubishi Galant that will idle fine but dies when you put it into gear I have already replaced the idle air control motor could it be the computer Or the transmission?

No, you may have to check your idle. You can change the idle so when you put it into gear it will not die. You must make sure that the engine is warm when you adjust the idle or it may make it hard to start when the engine is cold. When it idles in park or neutral it should sound a little higher than when it it idles in gear or drive or reverse.

74 challenger 360 4 barrel wont idle and dies when put in gear?

replace or rebuild the carburetor

What causes 1991 Honda civic to run rough in gear at idle but runs ok when taken out of gear?

Bad oxygen sensor

What is idle gear?

good gear

What is a idle gear?

good gear

What causes a car to not idle in gear but not while in park or neutral?

A vacuum leak (Brake booster).

Why does you 12 valve diesel with an automatic dies when i put it in gear?

The idle speed is too low, or there is an internal trans problem.

Why would your automatic car start fine idle fine but when you put it into gear it stalls?


What causes and how do you repair a 1974 Nova that starts but dies when it is put in gear after the oil pump was changed?

You are just starting it and putting in gear from an Idle? Rev it up does it miss? The dist is probly 180 degrees out, pull dist and make the rotor point in opposite direction

Why does 1992 silverado idle fine but when you drive it chokes?

If it drives fine but dies without warning while slowing down I'd bet on ICM.

People also asked