0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where must a suction line be placed in a heat pump after a motor burnout?
between the comp and the reversing valve
Will it strain the pool pump motor while running when the solar pool cover is on?
No
Where must a suction-line drier be placed in a heat pump after a motor burnout?
between the comp and the reversing valve
How do you install bearings in a northstar pool pump motor?
my northstar pool pump is making noise.I think it might need new bearings.How do I take the motor off./
Sand dollar pool filters what causes low presurecomimg from filter?
Plugged pump, very dirty filter. Do you actually mean the filter or the pump. Filter is big tank. Pump is small unit with motor attached.
Where is the impellar on a pool pump?
I had a look to se if I could find a craster pool pump and had no luck however the impeller on every pool pump I have ever seen is in the impeller housing which is bolted straight against the motor.
Where must a suction - line drier be placed in a heat pump after a motor burnout?
Between compressor suction and reversing valve,also called true suction.
Where must a suction line drier be placed in a heat pump after a motor burnout?
Between compressor suction and reversing valve,also called true suction.
Doughboy pool pump motor turns no pressure?
Possibly you have a broken shaft or you may have a problem with the condensers that are needed to get the motor turning in the first place. These are usually situated in a little box on the top of the motor. A: No broken shaft. The "condenser" is called a capacitor. If you can remove the motor take it into your local pool store and they can check the motor and capacitor. You then will need a new pump seal and gasket once you get your motor from the repair shop. k
Why does your swimming pool pump work when you plug it the garage but when you hook to swimming pool does not work?
You should never run a swimming-pool pump dry! The most likely problem, from the rather flimsy evidence in your question hinting at it not rotating, is not with the pump or its motor but a fault in the electrical supply to the pool plant, or in the timer or other pump controller.
Where is the impeller on the pool filter?
I had a look to se if I could find a craster pool pump and had no luck however the impeller on every pool pump I have ever seen is in the impeller housing which is bolted straight against the motor.
Can an older pool pump draw more amps to trip main breaker?
Yes, an older pump/motor can draw more amps. This usually happens when the motors windings are going bad or the bearings are going out. This causes the motor to have to work harder to rotate. It should have its own breaker. If its blowing your main, The motors windings are probably bad and the motor should be replaced.
