Want this question answered?
rear end is no good
right side under rear fender.
need free picture diagram for 1997 honda four wheeler rear end
There are seven steps on how to replace/change the gears in the rear end of a Polaris 325 4x4 four wheeler. Some of the step-by-step instructions are turn the ignition key on, pull in the clutch, and then push the shift lever down four times.
Its on the rear frame on a plate next to the tail light
It may have water in the rear diff or over filled the oil. Drain the rear and refill. Hopefully you get just oil.
my breaks stuck after we got the four wheeler back from a crapy mechanic. how do i get the drum off to free the breaks ?
it is simple, it is right below the head of of the atv. On a polaris scrambler it is right in front of the left rear fender
yes definetly
unscrew it. take it off.
To tighten the chain on a Honda 3 wheeler, first loosen the rear axle bolts then turn the adjuster nuts clockwise to tighten. Finish by tightening the rear axle bolts.
I had the same problem, but then I looked at the rear tires, the one on the right ( same side the chain is in ) was closer to the front of the four wheeler than the other tire. Then I lifted the rear of the quad and it was because my rear bearings were gone and needed to be replaced, which would pull the rear tires back in line tightening the chain.