Best Answer

read your owners manual. i had to also. there is only two vent settings that will not use the compressor. the vent setting with the upper and lower vent showing will use the compressor.

User Avatar

Wiki User

โˆ™ 2006-12-29 02:02:58
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: What causes air conditioner in 2004 Ford Ranger to run even when control is in vent position and no ac is desired?
Write your answer...
Related questions

Where is the air conditioner relay located on a 1999 Ford Ranger?

which is the air conditioner relay on a 99 ford ranger

Where do you add freon to your air conditioner in your Ford Ranger?

Answering "Where do you add freon to your air conditioner in your ford ranger?"

What kind of Air conditioner fluid for 1991 Ford Ranger?

R 12

Can a air conditioner compressor on a 1999 F-450 fit a 1991 ford ranger?


What position does Paul Ranger play?

Paul Ranger plays defense for the Toronto Maple Leafs.

Ford ranger air conditioner clutch engaging when air conditioner is off?

I'm investigating this as well. I have a 2008 and have been told the air conditioner is only off when you have the vents on the floor only. Still checking this out.

Where is the camshaft position sensor located on a 1999 ranger 4.0 v-6?

Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine

Where can you get a free wiring diagram for 1999 ford ranger's air conditioner? has online manuals

Ford Ranger idles rough?

Have the computer scanned for trouble codes. The problem may be a bad Throttle Position Sensor (TPS) or Idle Control Valve (ICV).

How do you change the air conditioner receiver drier in 1990 Ford Ranger?

I don't know how that is why I asked the question.

How do you test the air conditioner relay on '97 Ford Ranger?

Swap the relay with another like relay.

Where is cam position sensor on 1993 ford ranger?


Can a park ranger in law enforcement become qualified for a supervisory park ranger position?

Yes, if he meets certain criteria.

What type of freon for 1987 Ford Ranger air conditioner?

Would have been built for R12, can be converted to R134a.

Where is the camshaft position sensor located on a 2002 ford ranger?

The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.

Where is the wiper control module located on the 1997 ford ranger?

In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.

Where is cab air filter located in a 1999 Ford Ranger xlt?

There is no cabin air filter for a 1999 ford ranger xlt

What does the crankshaft sensor read on a 1996 Ranger?

Crankshaft position and crankshaft RPM

Where is the crankshaft position sensor on a 1993 ford ranger 2.3?

should be by balancer

What is the name of all the power rangers jungle fury?

The names of the 5 Jungle Fury Power Rangers are Casey, the Red Ranger, Theo, the Blue Ranger, Lily, the Yellow Ranger, RJ, the Wolf Ranger and Dominic, the Rhino Ranger. There are also the 3 Spirit Rangers with the spirits of the Elephant, the Bat and the Shark within 1 of each of them however the Spirit Rangers have no civilian identity due to being just spirits of their animals. Master Phant and Lily can control the powers of the Elephant Spirit Ranger, Master Finn and Casey can control the powers of the Shark Spirit Ranger and Master Swoop and Theo can control the powers of the Bat Spirit Ranger.

How do you hack ranger remote control on the computer?

become a hacker LOL

95 2.3 ranger is it equipped with an ignition control module?

Yes ( according to ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC

Where is the ignition module located on a Ford Ranger XLT 2.3l?

1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.

Where is the camshaft position sensor on a 95 ford ranger 4-cylinder?

There isn't one. It only has a dual vane crankshaft position sensor.

Where is the abs control module pump located on Ford Ranger?

The Hydraulic Control Unit for the 1995 Ford Ranger 4 wheel anti-lock brake system 4WABS is located in the engine compartment on the left front inner fender panel. It consists of: the brake pressure control valve block, pump motor and hydraulic control unit reservoir. The "brains" of the 4WABS in the Ranger is the Brake Control Module, or Electronic Control Unit (ECU). The ECU/Brake Control Module is mounted in front of the right front corner of the battery on the radiator support.