Want this question answered?
If the smoke alarm lasts for ten years before you need to replace it, and the batteries should be replaced at least once per year, you would need to change the batteries of a smoke alarm ten times before you replace the entire thing.
voltage drops on a weak battery can cause the alarm to trip. Whenever power is interrupted, even for a short time, the alarm will trigger. Sometimes not right away, but usually after the first drive after the power failure.
There isn't a fuse. On the drivers side wheelwell (you have to remove the rubber cover ) there is a box. Unplug the box and it disables the alarm. In the box is a pair of batteries that you can replace if you are decent at soldering. By replacing the batteries it will allow the alarm to work properly.
fire
2
The batteries in my hand held remote started getting weak and the car alarm would go off as soon as I tried to start the car everytime so I took the remote apart and took the batteries out until i could find new batteries for it. I just use the key with no problem with alarm anymore.
They do in Portland, Oregon.
a constant beep is the overheat alarm a beep that goes in and out is low to no oil alarm
No. Any wireless system that is not connected to a power outlet will require batteries.
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
change the alternator batteries
because it might be old or you need new batteries