Oxygen sag is a dip in the amount of dissolved oxygen in a body of water. This can be caused by several things, ranging from a drop in water flow to an increase in waste in the water. Occasionally when waste is introduced into a body of water, bacteria will begin to consume the waste. As they consume the waste, the bacteria use up oxygen, causing the overall amount of oxygen in the water to drop. In some cases, the waste itself will consume oxygen without an bacteria. Oxygen sag can lead to massive die-offs of oxygen-breathing aquatic creatures, such as fish, crustaceans and mollusks.
The Kayapo tribe have lip plates because large lips are considered beautiful. They are made by, as a small baby, the tribe member has his or her lip cut and a small clay disk is inserted. As he or she grow, the disk will be removed and replaced with a bigger one. The tribe member cannot remove the disk, or the lip will just sag.
Since large buildings with high walls and a high ceiling/roof tend to be flimsy (they can sag under their own weight), they are not considered good shelter against tornadoes. If the roof is ripped off (the roof is often the first to go), then the walls will be left unsupported, so they can collapse and crush people inside. Plus, being in a large, wide room can expose you to flying debris, such as broken glass from windows. Long-span ceilings also collapse fairly easily. The trick is to have as many walls between you and the outdoors, because they add protection. However, you may not get the full benefit if the walls are flimsy. For example, schools often have sturdy brick walls that are left standing even if the roof is torn away (bathrooms have this quality, too). It's best to stay away from gymnasiums and auditoriums and head to a basement, cellar, interior room, or hallway, and stay on the lowest floor.
What you are referring to is a plate boundary. A plate boundary is an area where two tectonic plates are either moving away, moving towards, or moving along each other. San Andreas fault is a plate boundary because the fault is located over two tectonic plates that are moving along each other.
The surface tension of liquid is responsible for that ,the tension at surfaces of a drop acts inwards to the center so drop tends to reduced its volume and the minimum possible volume for matter is a sphere and therefore a falling drop of liquid acquires the spherical shape.
sag
sag
SAG
sag
The address of the Committee For Sag Harbors Old Burying Ground is: Po Box 565, Sag Harbor, NY 11963-0012
"Dip" is the answer.
The critical speed of a SAG mill is the speed in RPM's at which centrifugal force causes the material being ground to be held against the inside of the shell. This speed is only dependent on the diameter of the mill.
my guess is a guy's sack? lol
The sag setting is necessary because it is physically impossible to have a suspended line with no sag. The sag is specified because there has to be a minimum clearance value for the height above ground at the centre of the sag where the cable is at its minimum height.
Foundations are the main cause of any building sinking. As the house moves its structure is under differing stresses and this causes the fabric of the housee o eventually break in areas such was walls, floor/ceilings and door ways and windows start becoming twisted.
The plural of sag is sags, not sag's! Sag is caused by the weight of the conductor between its supports, and is (a) unavoidable and (b) necessary to allow for the conductor's expansion and contraction during variations in temperature. When surveyors design a power line, the amount of necessary sag is calculated and built into the design, while ensuring that the clearance between the conductor and the ground remains within safe limits.
Gravity, genetics and pregnancy cause changes to the breast which effect their appearance, shape and firmness.