Possible causes include failed switch, motor, regulator, broken wire, blown fuse,
Bad regulator, it's common problem on 2001 models
Driver side front door panel.
They are not backlit
The rear washer is fed from the same reservoir as the front on a 2000 Chrysler Town and Country.
The problem may not be that the window has come off the track. I have a '98 Chrysler Concorde and the driver's side window wasn't operating correctly so I took the interior door panel off and found that one of the brackets that anchor the window to the track had broken. I tried to repair it with JB Weld but it didn't hold. I'm going to have to buy a new window.
There is a square button on the handle of the driver's side door (where the window buttons are). push the square button and viola!
The breaker is self resetting.
because there is a fault in the circuit
is for power window
each time the driver's door is opened and closed the electrical harness between the door and the door pillar is flexed, often this causes a break in the wiring, make shure there is power and no broken wires.
I recently had the same problem with a friends 01 Town and Country and it was the drivers side power window motor at fault. A Mopar mechanic friend of mine strongly recommended purchasing the power window regulator assembly with motor attached. If you separate the motor from the assembly, reinstallation is nearly impossible. The complete window regulator with motor assembly was just under $140. Installation took about an hour. Also, the dealership had the assembly in stock which tells me they sell many of them.
Replace the window regulator, it may come with the motor.