there could be a few things to look at first , is the check engine light on? if so then you want to get a shop or auto zone to run a computer diag on it you will probably find either a mass airflow meter or the idle air control is bad you can mail me @ tajohn4u@aol.com for further info
Look for a metal thing about the size of a thumb screwed into the exhaust system near the engine end.
Your low beams may have a short in the wiring system. It is also possible that the bulbs have burned out in both of them.Ê
by the lower intake manifold while you are doing this you should replace the intake manifold gasket anyway because it will leak sooner or later.
http://www.a1electric.com/install/grand/grandam-3.htm This link provides some instructions on an alternative type of pontiac, however the basics remain the same.
Bottom of the engine on the oil pan.
possably the switch at the brake? do your brake lights work??
the overflow reservoir, it should have marks for full cold and hot
I had a problem with stalling with a 2000 Impala, and it was the oxygen sensor.
Original belt? If so, the rubber's gone hard and is slipping.
do know where the horns on Pontiac Bonneville 2000 is do know where the horns on Pontiac Bonneville 2000 is
Yes.
show me where the starter relay is are on a 2000 Pontiac Bonneville