Want this question answered?
The condition you are looking for is a short circuit.
A circuit is the path that transmits electric current.A circuit includes a battery or a generator that gives energy to the charged particles .Circuits are classified according to the type of current they carry that is parallel circuit and series circuit.
The conducting path of a torch is a simple circuit: Battery to switch, switch to bulb, bulb back to battery. Provided the switch is on, and there are no breaks in the circuit wiring (and the bulb is good), the torch should work.
A circuit that has more than one path for the current to flow is a parallel circuit. The circuit must have two or more paths to be considered parallel. A circuit that has only one current path through multiple components is a series circuit.
Because there is only a single path in series circuit and many paths in parallel circuit.
The Vehicles frame unless fiberglass then the chassis.
This wire provides a low impedance return path to the distribution panel in case of a circuit fault. This direct fault current path will trip the circuit's breaker and open the circuit.
The battery is the power source of the circuit. It supplies current to the circuit and the circuit is simply a path for the current to follow. When you remove the current (battery), the path still exists but there is no current going through it.
The ground.
parallel circuit
provides just one path for current flow
Source which is the battery Object which is the switch Path which is the wire
An electrical circuit is a path which electrons from a current source flow. Electric current flows in a closed path called an electric circuit. The point where those electrons enter an electrical circuit is called the "source" of electrons. The point where the electrons leave an electrical circuit is called the "return". The exit point is called the "return" because electrons always end up at the source when they complete the path of an electrical circuit. The part of an electrical circuit that is between the electrons' starting point and the point where they return to the source is called an electrical circuit's "load". ---Nerd
The condition you are looking for is a short circuit.
Source which is the battery Object which is the switch Path which is the wire
It is a closed circuit if there is a load in the circuit (light bulb etc), otherwise it is a short circuit (+ to - on a car battery with a screwdriver)
When that circuit has no breaks. It is an endless path of current flow.