I just installed a brake controller on my 2009 Ranger several months ago. The wire you want to connect to on the brake light switch is the purple wire with the white stripe. This is one of two heavier gauge wires that are on the switch as well as some other lighter gauge wires. The other heavy gauge wire from the readings I got with my volt meter appears to be the power source. I must have got it right because everything has been working fine with the brake controller.
Typically a loose connection is either wires in a wire nut not making a proper connection, or a wire not tighten properly in a breaker and/or device e.g., outlet, switch, etc.
on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling
electric switch, electrical switch, control, controller
a controller.
1st check the power supply switch whether on or off then Check the all wiring connections may be wire disconnected or there is any loose connection(OFF the switch). smell the component whether it is heated or not and touch to experiance the heat(OFF the switch). replace the controller/motor with new one to detect fault present in which part.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
1995 ford ranger back-up lights stay on, replaced switch, how do you check for a bad switch
This is due to the headlight switch itself, failing. Also check wiring harness connection, where it clips into light switch. This exact situation happened on my 1988 Model Ford Ranger. After inspecting original light switch, the switch itself had one loose spade terminal connection, allowing the connection to heat up and distort the factory harness to the point where the terminal connection on the factory wiring harness(factory clip) would not hold the spade terminal correctly. The new headlight switch and some massaging and adjusting of the factory spade terminal ends will fix your problem. Good luck.......
02 ranger
The 1994 Ford Ranger pickup truck turn signal switch can be found below the dashboard. The switch will be on the drivers side. The turn signal switch should be labeled as such.
a/c switch is located under the hood, passenger side and attached to the a/c dryer. may you be talking about the fan switch, vaccum controller swtch or aux switch or lever switch, that make-up the climate controller in the dash.
how to replace the netural saftey switch