Want this question answered?
its a faulty connexion. wires may be broken or torn. get it checked out
grey
in front of the right front tire, remove lower plastic guard and pump is attached to fluid tank.... pull pump off and jump back as fluid drains out of tank... after fluid is gone unplug wires then plug wires in new pump and push pump into tank
it is in the same tank that you put the washer fluid in /// in the bottom of it , it has 2 wires and a black hose going to it on the outside bottom of the tank. it is in the same tank that you put the washer fluid in /// in the bottom of it , it has 2 wires and a black hose going to it on the outside bottom of the tank.
3 reasons the motor in the blade for the windshield has burnt out, the wires are burnt or the switch behind the steering wheel has died strange enough if all fail the the car to the Honda company and report the problem also the car might be second-hand which the original ower didn't know
In a Peugeot 306, the speakers are located inside the front doors. There should be four wires total, two for the speakers and two for the tweeters.
Black
It should be inside the Washer Fluid Holding Tank. Look on the bottom for wires coming off the tank.
very simply. Remove front passenger side wheel, there is a plastic mud gaurd like sheet that is between wheel and engine bay. remove this enough to allow you to work, three small bolt screws, 1 underneath and 2 on the side, also a plastic clip that kinda pulls off but to the right, once you can pull the plastic casing back enough to see in, the washer bottle is right behind. 2 wires go to each pump. there are two pumps 1 for front windscreen and 1 for rear. remove the wires by pulling them off the clip on connection then pull off the two hoses for the water, next the motors can be pulled from the bottle, they are only held in with a rubber seal. very simple just did mine for the first time in half hr.
That is the normal colour of aluminium.
If it's the same as in my Peugeot 306 (1997) you have to unplug the wires from the therminal-switch witch is located on the radiator. Then use a piece of wire to short circut the two connectors on the wires. Have the ignition on. When you short circut the wires the fan will start. (Thats basicly what the terminal switch do when the temprature reaches a certain point) Best regards Vegard H Johansen (NORWAY)
It is located under the windscreen washer bottle which is located under the front offside wing (rhd)How to remove and replaceI searched the web to find this answer and couldn't so after an afternoon of doing it here goes!First, I jacked the front of the car up from the drivers side front mount. Then turned the wheels to the right (no need to remove wheel). I removed the inside inner arch enough to access the area. You then need to loosen the horn bracket...one bolt, you can then see the pump with the hoses attached...a gentle pull out will remove. Make sure your legs aren't there as it empties the water out when removing ( I got soaked!). Un clip the wires and replace...Not difficult, I managed to remove with a few spanners and a couple of Alan keys