Want this question answered?
router
The command ip classless is enabled on the router.
ip route {destination prefix} {destination prefix mask} {interface OR forwarding router's IP address}
That's the command, on a Cisco Router, to show the routing table. It is one of the most important troubleshooting commands.That's the command, on a Cisco Router, to show the routing table. It is one of the most important troubleshooting commands.That's the command, on a Cisco Router, to show the routing table. It is one of the most important troubleshooting commands.That's the command, on a Cisco Router, to show the routing table. It is one of the most important troubleshooting commands.
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
The first router in the path to the destination network. The next hop router is the first (or next) router in the path to the destination network. Each router looks at the destination network in the packet, then consults the routing table to identify the next hop router to the destination network. The hop count identifies the numbers of routers in the path to the destination network. A default gateway router is a router that is used for packets used to external networks. Most routers do not have a default gateway setting, but instead use a default route setting which identifies the next hop router for all unknown networks.
use of routerrip command
ip classless
routedelet
It's cheese time
The ping command will send roundtrip packets to a destination ( other PC, router, printer, etc. ) and see how long it takes. The 192.168.0.1 is the destination ( which, by the way is a typical default IP address of a router. ) The -l 1000 is how big the packet should be in bytes. The default is 32, if the -l parameter is not used. And the -n 100 is saying to send it 100 times. The default is 4, when this parameter is not used.
the Layer 2 source and destination address