0
What else can I help you with?
Which commands con you use to determine who is logged on?
There are several commands depending on how much detail you want, and whether or not a certain package is installed on the system. The command 'who', 'w', 'users' will give varying degrees of information on who is logged in. The 'finger' command will also give some information but only if the finger software is installed.
Determine whether the TCP IP protocols are installed and functioning properly?
C: Attempt to ping the loopback address.
How can a driver determine whether the engine is running?
Look on your dash inside of your car. Next to your speedometer will be your tachometer. if it is on anything but zero, your engine is running.
You want to determine whether your Linux laptop has connected to it and obtained a valid IP address what commands will allow you to find the information you need?
use 'ifconfig -a '
If you want to determine only whether the TCPIP protocols are installed and functioning properly on your workstation you could?
Attempt to ping the loopback address
Which two commands can a technician use to determine whether router serial ports have ip addresses that are assigned to them?
"show interfaces" "show ip interface brief"
Does the Sony VAIO laptop crash often?
That depends on whether or not you obtain a virus while using it. Be sure you have a firewall program installed and running.
How much should it cost to have new thermostat installed in a 1995 Chevy Blazer?
I was just quoted for $80. I am hoping to determine whether or not this is a good deal.
If you have just set up a new wireless network in your house and you want to determine whether your Linux laptop has connected to it and obtained a valid IP address what commands wi?
ifconfig -a
What is the difference between internal and external command?
Internal commands are the commands that are executed <?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /> directly by the shell. These commands will not have a separate process running for each. External commands are the commands that are executed by the kernal. These commands will have a process id running for it. Internal commands are stored in the cmd.exe command interpreter, ex. Dir External commands correspond to a .com or .cmd file, ex.
Why might a scanner not work after being installed?
Please check whether you installed proper driver for your scanner.
How do you determine whether a rock is a rhyolite or an andesite?
The composition of the rock will determine whether it is a rhyolite or an andesite.
