st segments
Amperes
The current flow in an electrical circuit depends on the applied electromotive force (EMF, measured in volts), and the total resistance along the entire circuit. Rising EMF or dropping resistance cause increased current flow
Multi meterAnswerInstruments that measure current are called ammeters, and instruments that measure voltage are called voltmeters. An instrument that measures resistance is called an ohmmeter. Each of these functions can be combined into one instrument, called a multimeter.
In electronics, a center tap is a connection made to a point half way along a winding of a transformer or inductor, or along the element of a resistor or a potentiometer. ..
Electricity is the flow of electrons along a conductor.
Position is measured along one axis, and time is measured along the other one.
EKG paper is a grid where time is measured along the horizontal axis, of EKG graph paper and where to measure the components of the EKG wave form.
If I understand the question correctly, it is about the component of a vector along the axes, with the angle measured from the positive direction of the x-axis. If so, sin is used on the y-component.
No it is measured from the edge
Amperes
It is the distance, measured in the vertical direction, using centimetres as the unit of measurement. The vertical direction in a book is normally taken to be the direction from the bottom of the page to the top. Otherwise it is taken to be along the radius of the earth at that location.
Proton normally exist in nucleus. Along with it are neutrons.
When a function is graphed, the dependent variable is usually measured along the y-axis. This is because y is the function of x.
When a function is graphed, the dependent variable is usually measured along the y-axis. This is because y is the function of x.
No, it is measured along the top from where it starts to the tip.
Longitudinal waves are waves that are produced by disturbance that is parallel to that of the direction of wave or oscillations produced along the path of the wave. The longitudinal waves consist of areas of comressions, the center of which is in a crest, and areas of rarefactions, the center of which is in a trough. Crest in a transverse wave is the part of wave at the maximum above the isoelectric line (midline) and trough is the minimum below the isoelectric line. The example of longitudinal waves is sound waves.
Any vector could be resolved into perpendicular components one along x axis and the other along y axis. So all vectors would be split into two components. Now we can easily add the x components and y components. If all in the same simply addition. If some are in opposite we have to change its sign and add them. Finally we will have only two one along x and another along y. Now we can get the effective by using Pythagoras.