A bad battery terminal(s) connection, bad ground, bad ignition
switch, bad starter.
Mazda starting problems
Yes. Mazda part numbers: w/Cruise Control BR75-66-120D w/o Cruise Control BR72-66-120G w/o Intermittent Wiper ("INT" position on stick) BR70-66-120G
I Ran 205 55 16 on my 01 Protege, There is little clearance on the back but there are no problems with them.
Were is the egr on a 1992 mazda protege
where is the thermostat on a 1999 mazda protege?
Where is the headlight relay in 1992 Mazda Protege?"
Where is the thermostat location on mazda protege 2003?
Where is the igniyion coil on a2002 mazda protege
Where is the EGR Valve on a 1996 Mazda Protege located at?
Yes the 1994 Mazda Protege is a OBD 1 port
Every 60,000 miles in a 93 Mazda Protege
Yes they will fit. There is not a difference in part number for a protege or protege5.
where is the modulator vavle on my 1994 Mazda protege dx?
What's the firing order for a 96 Mazda protege
Where is the flasher relay on the 1999 mazda protege
Yes, 1999 Mazda protege window issues indeed....
You might have Mazda 6 starting problems because your battery is bad or because you have a damaged starter. You might also have problems if you have no gas in the vehicle.
Could you tell me how would you replace the oil pump on a Mazda Protege?
How you replace the cabin filter mazda protege 5 2003
That would be a Mazda Protege
how to replace the thermostat on a 2003 Mazda protege es 2.0
where is the transmission shift solenoid located on a 2001 Mazda protege
Hoo I set the correct timing on a 1993 mazda protege
DONT BE STUPID
need to know what wire go were for a 94 Mazda protege MAF sensor
Can someone please tell me how to hot wire the ignition of a 1991 mazda protege?
The 2000 Mazda Protege has electric fans, hence there is no fan belt to change.
No, the 1993 Mazda Protege DX does not have an airbag. The vehicle does have a passive restraints system and is extremely reliable.
How do you replace power steering belt on 2003 Mazda protege ?1.6
no it will not fit.it is not the same lenght and the same height
how do u replace alternator belt on 2002 mazda protege 5 stationwagon
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
2001 Mazda Protege ES uses tire size 195/55 R15
The ECM on the 2000 Mazda Protege is located on the backside of the engine. It is half way up above the drive shaft.
I have a 2000 Mazda protege. My fuel filter is in the gas tank and is not something you can replace. John B.
I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.
Hi Man Check the ignition coils. I just had to change mine. And the car working fine again Mazda Owner
The Mazda Protege fuel reset button can be found on the firewall in the engine compartment. The reset button will be in the middle of the firewall.
If your heater does not work on your 94 Mazda Protege, check the thermostat. You can also check the heater fuse to ensure it has not blown.
The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
A squeaky stick shift on a Mazda Protege likely needs greasing. It is recommended that you use a silicon grease for this.
The 1999 Mazda Protege DLC fuse can be found in the fuse box. The DLC fuse will be at the bottom of the first column.
po 170 fuel trim malfunction bank 1for 1996 Mazda protege
The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.
How to know if air sensor not working on protege 2003
Yes it does have ABS. The older Protege 1997 and older dosnt.
Yes it does I too own a Mazda protege 95 with a 1.5 liter and i had to replace the tone ring on my mazda. I ask what does this do and the shop told me its for the abs. But only the LX and ES model has it.
where is the starter
Cut your springs...