cable size for the 90kW motor is 3CX150sqmm aluminum cable
This is a good indication that the motor is being overloaded. If the motor load is belt driven, remove the belt and then check the motor amps. If it goes back to normal FLA then there is a problem with the driven load. If the motor amperage stays high check the motor bearings for the problem.
yes the motor will run but will draw more current and the torque will be not constant means not smooth due to unbalanced current
P = iv
The bulb with the lowest resistance. Current = Volts / Resistance
90/3=30ma
cable size for the 90kW motor is 3CX150sqmm aluminum cable
Maximum current is defined by the rated KW of the device, say Motor. The motor may not run at its maximum rated capacity all the time. Nominal current is drawn when motor runs at nominal load.
This is a good indication that the motor is being overloaded. If the motor load is belt driven, remove the belt and then check the motor amps. If it goes back to normal FLA then there is a problem with the driven load. If the motor amperage stays high check the motor bearings for the problem.
Locked rotor current is the amount of current a motor would draw if you energize the motor and the rotor (the spinning shaft) doesn't spin.
Because full speed is unloaded. As you load the motor, speed decreases, and slip increases, with an accompanying increase in current.
It will draw a heavy current and coils will be brunt.
0.4166666
Excessive resistance (drag), will cause motor to draw more amps (current flow) to operate.
yes the motor will run but will draw more current and the torque will be not constant means not smooth due to unbalanced current
All motors draw less current when their load reduces.
defective motor will not run, also cause the blower motor speed resistor to burn out and eventually blow the fuse. a motor with defective bearings will draw excessive current causing either the fuse to blow or cause the motor to overheat