A layer 3 switch or a router.
(1)Disconnect your device (2)Check if the device is switched to USB Debugging mode (3)Connect again
Encrypted communication between 2 points.
Bridge
A router or a Layer-3 switch can connect 2 or more LANs together and control data flow between them.
There is a device you can connect to the PS2 to hold 4 controllers.
YES you need 2 tamas (same version) and press the connect button ect.
AnswerVLANs are created on Layer 2 switches to control broadcasts and enforce the use of a Layer 3 device for communications. Each VLAN is created in the local switch's database for use. If a VLAN is not known to a switch, that switch cannot transfer traffic across any of its ports for that VLAN. VLANs are created by number, and there are two ranges of usable VLAN numbers (normal range 1-1000 and extended range 1025-4096). When a VLAN is created, you can also give it certain attributes such as a VLAN name, VLAN type, and its operational state. To create a VLAN, use the following steps.1) Configure VTP. VTP is a protocol used by Cisco switches to maintain a consistent database between switches for trunking purposes. VTP is not required to create VLANs; however, Cisco has set it up to act as a conduit for VLAN configuration between switches as a default to make administration of VLANs easier. Because of this, you must first either configure VTP with a domain name or disable VTP on the switch.2) Create the VLAN. VLANs are created by number. The two ranges of VLANs are as follows: The standard range consists of VLANs 1 to 1000. The extended range consists of VLANs 1025 to 4096. Extended VLANs are currently supported only on switches running COS software version 6.1 or greater. When you create a VLAN, you have many options to consider. Many options are valid only for FDDI and Token Ring VLANs. Some of the items configured deal with options, such as private VLANs, which are discussed in other sections in this book. VLANs are created using the set vlan command for COS devices or with the vlan command in vlan database mode for IOS switches.
For a home networking system you would need: Ethernet Cables Router and an ISP (internet service provider) 1. connect your ethernet cables to the PC and to the Router 2. Connect to the ISP
You can buy a USB to serial converter (if they make them) of you can also ghetto one.
two
We know that a router is a layer 3 device means Network Layer. Router is a only device that can forward only uni cast massage. If u configure the router well and connect the two separate network, i think the network will go finely.
an access point device is one of 2 things. a router, or wireless router connection usb device. with the usb device, you can connect an office computer wirelessly to a wireless router. in the situation of a laptop, it is always the router itself. some routers will require an access code to use.