Want this question answered?
A DC-to-DC converter is the general term for a device that changes DC voltage at one level to another.
A Voltage Controlled Amplifier or VCA is a device whose gain is set by the voltage level of a control signal.
transformer.
convert signal gains or losses to comparative decible reading.
Nothing can change electric current to voltage. You can compare "current " to rate of flow, while "voltage" is the energy level. Transformers can be used to increase or decrease the voltages of alternating current as is done from 'street power' to domestic power.
A series regulator maintains the output voltage at a constant level by constantly changing the effective resistance of the pass device, usually the output transistor.
Convert in coming signal to D.C. using a bridge rectifier. Use the voltage to run a voltage to frequency converter. You will have to scale the incoming signal to match the frequency range desired.
electronic volume can be measured by using transducer transducer is a device which convert non electrical signal to electrical signal. First you need a microphone which is a transducer after that apply the sound vibration on this microphone it will produce a voltage the voltage is directly proportional to applied sound volume level. it measure in decibel.
CT metering circuit can not be used to measure voltage
"Vout" typically refers to the output voltage of a circuit or device. It is the voltage level that is generated or present at the output terminal or node of the circuit. Voltage output is a common measurement parameter in electronics and electrical engineering.
To convert voltage levels to DB you must first specify a reference, then take 20 x log(base 10) of the ratio of the voltage level in question to the reference. For example, if the reference is 1 volt and the signal of interest is 100 volts, then the level in dbV is: 20 x log10 ( 100 / 1 ) = 40 dbV
BIL stands for Basic Impulse Level, it is the impulse voltage or power ( in the case of testing a transformer) or surge voltage in the case of lightning or switching, that a transformer or any other electric device is able to with stand. It refers to maximum voltage a device can with stand with out insulation breakdown which leads to a short circuit.