Want this question answered?
corrosion-resistant steel
Water can be evaporated from a sealed container.
Each shell represents a distinct state of electron energy.
There are 100 centimetres in a metre. So, if the water can be considered as solid cubes each one centimetre along each side then a line of 100 would cover the width of the container. A square 100 wide by 100 deep would cover the base of the container. A further 99 layers would fill the container. So now we have 100 x 100 x 100, or 1,000,000 cubes of water each 1 cm3 in volume As 1 cm3 is 1 millilitre, which is 1/1000 of a litre, then 1,000 litres would fill the container.
No because it must be at least one molecule thick. If the liquid would get that thin it could go pretty far. But this is not the case. With water this is naturally not the case. Water tends to stay near water. So if you where to put a cup of water in a huge container....... you would just have a puddle.
A container is able to hold water because the container's atoms are bonded closer together than each water molecule's total size. This prevents the water molecules from sliding out between the container's atoms, thereby holding the water inside.
There are two containers that contain molecules. Container a and container b. Container a contains carbon dioxide, and container b contains water and carbon dioxide molecules.
c
A container that holds water.
The container is a cube, therefore if one side if 50cm each side is 50cm. As such, the volume of the cube is 50x50x50, or 125,000cm3. Pure water weighs 1g/millilitre, and 1mL is equal to 1cm3. Therefore the mass of water in the container is 125,000g, or 125kg.
corrosion-resistant steel
I boil tap water in three gallon stainless steel container and each time the water cools a fair amount of white mineral precipitates - Ca + Mg - collecting on the interior surface of the container, also a fai amount freely precipitates and collects at the bottom of the container. I have drank the water for years.
The container that you can boil water in is called a beaker.
Take the mass of each liquid, divide by the volume, and that gives you density. If the density is nearly 1g/mL, it is water.
Flute
Water convection is the movement of water in a circular motion due to cooling and heating. The water near the bottom of the container is heated and moves up the container, while water at the top of the container is cooled and moves down the container. Convection causes movement of the water.
Water can be evaporated from a sealed container.