answersLogoWhite

0

What did the Proton Persona replace?

User Avatar

Anonymous

12y ago
Updated: 8/20/2019

The Proton Persona replaced the Proton Preve. The Pronto Preve was in production until the year 2007. It had been redesigned as the new model and was better accepted.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

When was Proton Persona created?

The Proton Persona was first introduced in Malaysia in August 2007. It is a compact car produced by the Malaysian automaker Proton.


How do I replace the fuel pump of Proton Persona?

Sell the useless junk if the fuel pump fails so quickly.


How do you change a hazard switch on a proton persona?

To change the hazard switch on a Proton Persona, you typically need to remove the trim piece surrounding the switch and then locate the mounting screws that hold the switch in place. Once the screws are removed, disconnect the wiring harness and replace the switch with a new one. Be sure to test the new switch before reassembling the trim piece.


What is the Cooling system of Proton Persona Elegance?

sanden or patco either one


How do you fix speedometer on 2002 proton persona?

there is most likely a censer on one of the wheels of the vehicle


Where is the starter motor on proton persona 1.3?

It is located below the intake manifold. It is located below the intake manifold.


Why is there no resistance on the clutch on a proton persona 1999?

There may be no resistance on the clutch of a Proton Persona 1999 due to a leak in the hydraulic system, a faulty master or slave cylinder, or air in the clutch line. It is recommended to have the clutch system inspected and repaired by a professional mechanic to determine the exact cause of the issue.


I am lookin for proton persona car dealer in romford?

Just contact service 4 service I think they can help you www.service4service.co.uk


How do you reset proton persona car alarm system when the remote is spoiled or out of battery?

push the small button about 3 sec.


Where is the auto transmission filler on Proton Persona?

The automatic transmission filler on a Proton Persona is typically located on the side of the transmission housing. It is usually a red or yellow cap that is marked with transmission fluid symbols. Make sure to refer to the vehicle's owner manual for the exact location and proper procedure for checking and adding transmission fluid.


How do you change front indicator bulb proton persona 1997?

Inside the bonnet at the rear of the indicator light fitting is a steel ring. This is a clip-in spring fitting. Once unclipped the indicator unit slides out. The bulb is attached by a simple push on fitting.


How often does a cambelt need to be changed on a proton persona?

The cambelt on a Proton Persona typically needs to be changed every 60,000-80,000 miles or every 5-7 years, whichever comes first. It is important to consult the manufacturer's recommendations and have it replaced according to their specified intervals to prevent potential damage to the engine.