If you think to filtration sand is a residue.
we can separate salt and sand by solving the mixture into water salt is soluble but sand is not .
To get rid of any residue that is left behind. Eg) a mixture of water and sand. You filter the sand because you only want the water.
You get a mixture of salt and sand. Nothing more happens.
Firstly, sift the mixture to separate the gravel from the sand and salt. Now place the sifted mixture into water. The sand will sink to the bottom and the salt will eventually dissolve. Pour this watery mixture through filter paper to catch all of the sand. If you want the salt back in solid form, simply boil the water.
Filter the sand out, and then evaporate the water, salt is left as dried.
Salt and sand is a mixture.
You place the salt / sand mixture in warm water. The salt will dissolve in the water and you than then four the salt solution off the sand, leaning just sand. Then boil the salt solution untill all the water evaporates, leaving the salt.
Pour water into the mixture, let the salt dissolve.Then, put the wet-salty water-sand mixture through a sifter/filter.Take out the sand from the filter and dry it. COMPONENT 1 - SANDBoil the salt water solution and evaporate the water. The residue will be salt. COMPONENT 2 SALTDissolve the mixture in water first, before filtering the resultant solution. The residue is the sand, while the filtrate is the salt solution.
we can separate salt and sand by solving the mixture into water salt is soluble but sand is not .
Mixture
Sand+salt: a heterogeneous mixture.
by putting all of the substances on a sheet or plate and then using a magnet underneath to pull the iron fillings away. then for your table salt and white sand you just use small mesh and voila! all wrong ... 1st, use magnet to separate the iron filling from the mixture of sand with table salt 2nd add water to dissolve the salt from the mixture with the sand and filtrate the liquid sand has separated from mixture of salt 3rd place the the filtrate liquid to a burner with a evaporating dish, the water will be evaporate and the remaining residue would be the small crystal particles which is the salt.
Put the mixture in water and wait for all of the salt to dissolve. Then filter out the sand and wait for the water to evaporate in the sand/water solution to get the sand and salt separately.
First heat the mixture; the iodine will sublime and turn to a vapor which can be collected. Then add water to the remaining salt/sand mixture; the salt will dissolve but the sand will not. Finally, evaporate the water to obtain the solid salt.
You get a mixture of salt and sand. Nothing more happens.
To get rid of any residue that is left behind. Eg) a mixture of water and sand. You filter the sand because you only want the water.
mixture of salt and sugar, sand and soil etc.