0
What distributor do you need for a carbureted 2.8 V6 Chevy engine?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the distributor cap for 1991 Chevy s10 truck?
We need to know which engine it has.
What is the firing order on distributor cap on 1992 Chevy van?
We need to know what engine it has.
Where is number 1 on the distributor for a 85 chevy s10 pickup?
Need to know what engine it has.
Where is 1 position on distributor cap for 1995 Chevy s10 v-6 engine?
Need to know what engine you have.
What does it mean if the distributor was replaced on a 1997 Chevy s10 and there is still a code?
It could be that the distributor was not the problem. Need to know what the code is and what engine you have.
How do you make an engine harness to install a 1986-94 350 TBI Chevy engine in an older carbureted vehicle?
You would need to carry over the entire harness including computer from the TBI engine.
Where is the distributor cap on a Chevy S-10 Blazer?
Need to know what year and what engine to help you.
Do you need to change the distributor on a new 350 crate engine to install it in a 57 Chevy?
i have a gm goodwrench 350 with a summit hei distributor in my 58 Chevy truckits about 1/2 inch from my firewallso... little room to spare but yes it worked
How do you reset timing on 1973 454 Chevy after replacing distributor cap?
No need to if the distributor was not moved.
Can you switch a carburetor from a 305 Chevy to a 350 on 1985 c 10?
First of all the 85 is a fuel injected engine, You can not put a carburetor on a fuel injected intake manifold it won't even fit.And if you put a carbureted intake on it you will need to change the elect fuel pump in the tank, the distributor and you will need to DRILL out the 4 center bolt holes in the intake manifold too. Plane and simple THE ENGINE WON'T RUN WORTH A...................D...M need to keep it fuel injected.
Where is the ignition coil located on 1999 Chevy astro van?
On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.
What parts do you need to install a Chevy HEI distributor into a Jeep 258 6 cylinder?
If my memory is correct you need a distributor from a Chevy inline 6, a distributor drive gear from an AMC 360 V8, and plug wires from a Ford inline 6
