First, you need to clean the tiles with a product that will remove soap scum. Scrub or brush both the tile and its grout. Then spray a bleach solution (1cup of bleach to 1 gallon of hot water) and let sit awhile. Do this only in well ventilated areas. Wear gloves, and old clothes you don't care about in case the bleach splashes. Depending on how long since the grout has been cleaned, you may need to repeat the process several times. If you notice the grout is cracked, or missing you will need to scrape it out (an old screwdriver works well) and replace the grout when the whole area is dry.
Algae are peculiar in that they will actually die off when doused with vegetable oil.
You don't actually need any expensive pool chemicals at all.
As an alternative (oil might get messy) you could use toothpaste.
Lotsa chlorine and lotsa brushing and lotsa filtering.
Just paint it white!!
Roughcast walls, like stucco or plaster can be cleaned using a mild detergent and water. For large walls a mop can also be used to clean the roughcast walls just like cleaning a floor.
Roughcast walls, like stucco or plaster can be cleaned using a mild detergent and water. For large walls a mop can also be used to clean the roughcast walls just like cleaning a floor.
The japanese put white plaster on the walls because it is fireproof
Try a heavy coat of primer/sealer. The primer should condition and adhere to your plaster walls. Once the primer sets up (dries) you can then apply anything you want to those walls.
You drain the water then plaster the walls from inside
Paint with bleach and then clean with high pressure hose
does it cover repairing plaster walls and repainting and fixng plumbing
Red algae cell walls contain agar. while green algae cell walls contain cellulose Answer 2 Agar is a chemical obtained from walls of certain red marine algae .It is not Algae itself .
Kal-Kote Finish Plaster is a white finish plaster that can be troweled on and left with a smooth or textured finish, over base coat and on top of blue board. We also use this plaster when we are resurfacing existing walls and ceilings that have been prepared using plaster washers and fiberglass mesh tapes over the cracks, and gluing the entire surface with "Plaster Weld " ( a Larson product ) to create a bond over previously painted walls and ceilings . We also tint the plaster to make any color desired , and apply two coats of machined buffed wax to give the walls a satin smooth finish burnished with steel wool .You will never have to paint again !
Kal-Kote Finish Plaster is a white finish plaster that can be troweled on and left with a smooth or textured finish, over base coat and on top of blue board. We also use this plaster when we are resurfacing existing walls and ceilings that have been prepared using plaster washers and fiberglass mesh tapes over the cracks, and gluing the entire surface with "Plaster Weld " ( a Larson product ) to create a bond over previously painted walls and ceilings . We also tint the plaster to make any color desired , and apply two coats of machined buffed wax to give the walls a satin smooth finish burnished with steel wool .You will never have to paint again !
Stucco