Want this question answered?
The main circuit board of a computer is referred to as the motherboard. It's called a motherboard. any smaller circuit boards attached to it that stick out the back are called PCI cards and have different functions (networking, sound, video and such)
if you mean those that are perpendicular-they're the ones that stick out the back of a desk top usually. however, most of your hardware is internal, like pci cards, sound cards, etc... all must connecdt to the mother board through ports
You shouldn't need any tools to add RAM to the motherboard of your computer - other than the screwdriver needed to open the case to gain access to the motherboard. If you're replacing a stick of RAM that's already in place, there will probably be a snap on either side that will need to be gently pushed down/away from the stick until it clicks - releasing it.
Stick-slip machines are designed to provide more controllable motion than a traditional electric motor. The basic design consists of a motor a control board and a stick-slip mechanism. The motor is used to provide the power to move the stick-slip mechanism while the control board is used to regulate the speed and position of the mechanism. The stick-slip mechanism consists of an elastic element such as a spring or rubber band that is connected to a shaft. When the shaft rotates the elastic element is compressed and then released creating a stick-slip effect. To design a stick-slip machine the following steps must be taken: Choose an appropriate motor and control board. Design the stick-slip mechanism and select an appropriate elastic element. Select the appropriate shaft and bearing system. Integrate the motor control board stick-slip mechanism and shaft into a single system. Test the system and adjust as necessary for optimal performance.By following these steps it is possible to design and build a reliable controllable stick-slip machine.
A USB stick (or memory stick).
No sport consists of only a long stick, though many use one as part of the play.
Remove the RAM stick from the motherboard and then desolder it from the PCB. But after dont put the RAM stick back in, unless you wanna break your computer.
A USB stick (or memory stick).
There are many board games in which one might use stick figures in their drawings. Examples of board games where one might use stick figures in their drawings include Cranium and Who? What? Where?, a drawing game.
If you have a Compaq computer, then stick with the compaq motherboard. Otherwise, go with Super Mico.
No sport consists of only a long stick, though many use one as part of the play.
A wheel from your skate board may work on a rip stick. It should be an outdoor wheel and needs to be 77mm or smaller.