Want this question answered?
you will need to swap intakes too. or i think someone might make adapter plates for the throttle body but im not sure.
You can change your 1986 305 cubic inch pickup engine from a carburetor to fuel injection. The problem with doing so is the cost. It might cost more to do the change than it would to purchase an engine.
it will work but u have to make sure if u have a fuel injection system that u get a fuel injected 305 or if u have a carbeurated engine that u get a carb 305 or else it won't match up
yes it will you would use the intake and carb and you would loose the fuel injection un less you swap heads
Depending on weather it has the 305 V8 Or weather it has the 4.3 V6. If it has the 4.3 then it will have throttle body fuel injection. On the 305 It will have a carburated.
Chevy had cross ram fuel injection in 1982 on their 305 camaros
Take breather off an read on carb if clean. Count jets in carb. Read sticker near radiator on top if stock an still readable. Assumin its not fuel injection
On a 92 van it should be a throttle body fuel injection set up and they need 9-14 psi. If it is a carb it would be 3.5-4 psi
in the fuel inlet on the carb.
pull the gas tank down and it's inside the tank.
NO, intake will not fit.
This is a fairly easy swap....and yes it works fine. The only problem you may have is the fuel injection. If you use the 305 injection on the 350 it may not deliver quite enough fuel. Most of the time however, this is not a problem. It will usually compensate for the additional cubic inches. If you do have the 350 injection use it just to be sure.