0
What else can I help you with?
What is small computer serial interface used for?
I am assuming you mean what is SCSI used for? In this case, SCSI does NOT mean "small computer serial interface," instead, it means "Small Computer SYSTEM Interface." SCSI is used as a fast interface between a host adapter and the CPU that can daisy chain as many as 7 or 15 devices on a single bus.
Does bluetooth use parallel interface?
No, bluetooth is a serial interface.
What does 'high-speed desktop serial interface' mean?
it is a communication port which recives and sends data serialy
What are the types of network interface card?
Gigabit Ethernet interface Controller interface Serial interface Multilink Group interface MFR (Multilink Frame Relay bundle interface) Dialer interface Loopback interface Tunnel interface ATM interface
Which interface would you use for a WAN connection?
Serial
What commands are used to configure a serial interface for the DCE?
interface serial x/x ip address x.x.x.x x.x.x.x no shut clock rate xxxxxxx end
1what type of interface connects a device to the system unit by transmitting data one bit at a time?
A serial port is an interface in which one bit of data is transmitted at a time.
When must a router serial interface be configured with the clock rate command?
When the interface is functioning as a DCE device
What do you mean by admin down in router serial interface?
admin down basically means that an adminstrator shutdown the interface for any number of reasons, and if the admin wanted to, they could bring it back up with the 'no shutdown' command.
Cisco router 2801 serial port is manually down how you can enable this port?
router> enablerouter# configure terminalrouter(config) interface serial (interface number)router(config-if) no shutdownrouter(config-if) endrouter#substitute (interface number) for the actual int number.. eg serial 0/1you can find the number of the interface by using show interfaces from privileged mode
What is mpp-1150 interface?
An mpp-1150 interface is used with the Atari computer serial interface that connects to a printer 36-pin Centronics connector.
What is the result of using the clock rate 56000 command at the serial interface of the router?
The interface is configured as a DCE device.
