You use PVC glue or cement.It's really quite easy.First you clean the pvc with solvent,then you put on the pvc glue.You want a little more than will cover the joint,but not enought to drip.You hold it together for about a minute.Wait an hour before you run water through it.
Pvc pipes are cheaper. They are easier to join. They last longer.
Chlorinated - PVC normally used on hot water
The pipes are PVC electrical conduits.
yes it can use
Yes, the reason for this is PVC pipes do not last as long and galvanised piping can survive in any kind of weather climate. Depends.. Water quality, sun exposure, climate and flow rates
Pvc pipes are cheaper. They are easier to join. They last longer.
PVC pipe fittings are used to connect and join different sections of PVC pipes together. They provide a secure and leak-proof connection, allowing for the smooth flow of liquids or gases through the pipes. These fittings come in various shapes and sizes, such as elbows, tees, couplings, and adapters, and they can be used for a wide range of applications, including plumbing, irrigation, and construction.
Simple. Rip out the old and relay with PVC using good quality piping. Where you need to join to old fittings and new there are joints that marry the two.
PVC is a compound.The pipes are not a compound but they are made from a compound.
PVC stands for polyvinyl chloride, which is what PVC pipes are made of.
pvc solvent cement is a liquid chemical compound, which is applied on pvc or cpvc pipes to join them or weld them together through achemical reaction , it is not difficult to make but is difficult to handle as its raw materials need very much care attention and knowledge, so better go to my site and look for the technical know-how report for making pvc solvent cement, my site is how2make(dot)in Dr javid Ahmad Dar PhD
Because modern PVC and PEX pipes are much more efficient and easier to work with.
No, you don't REALLY need it, but it has to be glued with something, and the correct glue is no more expensive than anything else.
It is a type of glue used for gluing pipes together... (not the type of cement in concrete).
You can not glue brass directly to PVC pipe. Use male/female adapters to join these two materials. ie, a male threaded PVC end fitting glued to the PVC pipe and a female threaded brass fitting screwed onto that.
You use PVC adhesive with a primer to join PVC pipes. Prime both pieces first, then after primer is dry paint a coating of glue on both pieces and force together, hold for at least 3-4 minutes for best joint. This will not cure for at least 4 hours so don't put any liquid in pipe for that period.
These days PVC pipes are faster and easier to fit and in many ways more efficient than cast iron.