0
Add your answer:
Earn +20 pts
What is line in line regulation?
Line refers to the a.c. supply line. Line regulation is the change in output of a device, usually a power supply, which is due to variations in the voltage of the a.c. supply.
Can I use automotive gasket maker on the threaded steel pipe for the toilet supply line?
no
How do you connect water lines to a kitchen faucet when the line coming out of the faucet is copper and the nut is stripped?
I have never seen a faucet that has a nut on the line coming out of it. Usually it is a male connection and the nut is on the supply line between the faucet and the house supply. Anyway, if the line coming out of the faucet is messed up, you could probably cut it and use a compression fitting to go between the faucet and the supply line to the house line.
Is it advisable to use line to neutral power supply on a single phase residential area when the safety is concern?
line to line or line to neutral is the only way to use power line to ground if a FAULT current in the ground is a problem that needs to be corrected, an insulation fault
What is the purpose of a supply line in plumbing?
supply potable water
Vlotage on motor name plate is line or phase voltage?
The voltage tag on a motor says 120 or 220 volt and some motors have jumpers to wire it for either one. That is the supply line voltage. The motor knows how to use that. If the plate says three phase is required then consult your electic supply Company for a three phase supply line.
What is a pressurized supply line?
A supply line filled with air, gas, steam, or liquid that's under pressure.
Can you use phase voltage as a single phase?
A single phase supply can be obtained between any pair of line conductors or between a line conductor and a neutral conductor.
How do electric companies know how much electric you use?
They have a meter in between their power line and your electical supply line going to your home circuit breaker panel. "Look fer it!"
Can you convert 415v 3 phase to 230v single phase?
415V 3 phase is the line to line voltage. The line to neutral of this supply is 230V single phase. Therefore you use one of the phases and the neutral.
What was the supply line plans of Confederate General Robert E. Lee for his raid on Maryland?
Because the plans of Confederate General Robert E. Lee were to remain in Maryland through the Fall of 1862, he needed a line of supply inasmuch as he was far away from Virginia. The supply line would also be a communications line as well. Supplies he knew he would need were ammunition, clothing, salt and sugar. His plan was to use a supply wagon route that began at Winchester, Virginia, through Harper's Ferry and then in to Maryland.
How do you fix supply line feeding from galvanized pipes?
Depends what is wrong with the supply line. -Be more specific, "fix" is just too vague
