if your mouse have a litlle ball in it you have to take the ball andd clean the mouse but if the mouse have a lassser i dont know
Use compresed air to blow out dust. Clean the rollers with a cotton swab dipped in a very small amount of liquid soap. The sticky side of duct tape works well to clean the mouse ball. You can purchase a cleaning kit for the mouse, trackball, and keyboard.
Remove the cap with the hole below the mouse, remove the ball and clean it, and clean the rolling cylinders that you will find inside the hole were the ball came from.
Ball mouse: Your rails likely have gunk or dirt built up on them causing a uneven flow and roll from the mouth, there for causing the mouse to be jumpy. Clean your mouse. Laser mouse: Dust or dirt on the laser sensor or a poor tracking or mirrored/shiny surface. Clean your mouse. Bottom line, clean your mouse.
clean the rubber ball and rollers in the mouse
Usually the ball is dirty or the wheel inside that rides on the ball has become caked with junk. Turn over the mouse and remove the ball, you'll probably need to turn the retaining plate, but some are a little different. Figure that part out by looking at the bottom of the mouse. Once the ball is out, clean and dry it. Then look at the three wheels inside, where the ball just came out. If the mouse isn't tracking horizontally, the SIDE wheel is probably dirty. Use a cotton tipped cleaner and a little alcohol to clean the wheel. Don't put too much pressure on it but it's ok to turn the wheel while you clean it. When you're finished, put the DRY ball back in and close the retainer. The mouse should work now, unless there is something seriously wrong with the mouse, in which case, don't worry, they're cheap.
If a ball mouse: Take out the ball every so often and clean in the hole as dust usually collects in that area. If a Lazer or optical Mouse: you do not really need to carry out maintanance but try to keep the mouse clean and make sure parts are clean.
Remove the ball, beneath which you will see two roller bars or rods at right angles. Clean the dust or debris from the rods/bars. Replace the ball and use. If it still won't work, reload the mouse driver software.
Optical
Soft Cloth
what is roller ball mouse
Use baby wipes to clean a computer mouse.