A Master lock is no different from any other lock. Using shims if it's a padlock, or picking it traditionally will open a Master lock the same as any other lock.
In fact, Master locks are fairly easy to pick.
I have tried with the paper clip with the master lock but it doesn't work. I think a bobby pin might do the trick.
Get a Tension and a screwdriver and pocketknife.... Use the PocketKnife to slip the pocketknife through the side of the door.... Use the screw driver to broke the lock..... Use the tension to pick it.....
Just like any other key ... except that a master key will open more than one lock.
you equip the lock pick and you click and then you have to hit wasd and find out which key is the right one or just use a disposable pick if you have one on PC
Master Lock was created in 1921.
There is no "master combination" that can open any lock. There would be no use for the lock if that were the case.
The motto of Master Lock is 'Tough Under Fire'.
Essentially you set the picks in a tubular lock pick to "past flush" meaning they extend beyond the housing they're normally inside. Once there, press them flush by pushing the pick down on a table or other flat surface. Next, tighten the collar of the tubular lock pick. Once the collar is snug, place it in the key in knob cylinder for the lock. This should "impression" the required key onto your tubular lock pick. Extract the pick slowly while turning it, and you should open the lock. You should also be left with the calibrations for that lock's key on your pick, which will enable you to duplicate it or simply reset your pick the next time you want to pick that lock.
You don't. There's nothing to pick. They can be "cracked" or "bypassed" easily enough, but "picking" is by definition, the insertion of a tool to place pins into an appropriate position. A combination lock has none of those features and thus can't be picked. The best way to bypass a master lock is with shims. That's the easiest method. There are several ways to crack locks as well however, but most of those are far more involved than simply using a shim.
pick the lock or use a skeleton key
no you have to use an action replay
use a fire hyderant and bang it in a downward motion hitting the lock. do this a couple of times and it should do the trick.