0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace the idler pulley on a 1997 dodge caravan?
Remove the belt, then remove the bolt holding in the idler pulley.
What is the name of the pulley on a 1997 dodge stratus 2.5 V6?
There is a crankshaft pulley, alternator pulley, power steering pump pulley, AC pulley, idler pulley, tensioner pulley, etc.
How do you replace the serpentine belt on a 1997 Ford Thunderbird?
Remove your idler pulley first. it is the pulley right next to the alternator.
How do you replace an idler pulley on a 1997 Ford F150 5.4ltr?
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
Is the idler pulley on a 1997 firebird bolted?
when looking at the front of the engine it is below the altinator slightly to the right
How do you tighten the serpentine belt on a 1997 jeep?
A serpentine belt has an idler pulley on is to keep it tight at all times. If your serpentine belt is loose, then something is worn out. Its possible the idler pulley is stuck in its bracket so it cannot move or the spring on it is worn out.
How do you change an ac belt on a 1997 Toyota landcruiser?
The A/C belt uses an idler pulley accessed from under the car. That lock nut is in the center of the pulley, and the ajustment bolt is located on the side of the pulley.
Torque specification on 1997 powerstroke belt tensioner and idler pulley?
40 lbs-ft (+/- 5 lbs-ft)
How do you replace an idler pulley on a 1997 Nissan Maxima?
3 bolts above your oil filter may have to move belt a
1997 Mercury Mountaineer makes squealing noise when idling?
Check the condition of the accessory drive serpentine belt, belt idler pulley and belt tensioner pulley bearings.
Why does your car eat up belts on your 1997 ford tuarus?
Misaligned or bent pulley. Defective idler pulley. Incorrect belt being installed. The belt must be an exact match, or it will self destruct.
What is the belt routing on a 1997 GMC Yukon?
There should be a sticker under the hood on the radiator support that shows proper belt routing. Alo check belt tensioner for weakness and idler pulley bearings for wear. They go bad very often. The belt goes over the alt,under the idler pulley,over the a.c. comp,under the crank pulley,on the inside of water pump, and around tensioner pulley. There should be a sticker under the hood on the radiator support that shows proper belt routing. Alo check belt tensioner for weakness and idler pulley bearings for wear. They go bad very often. The belt goes over the alt,under the idler pulley,over the a.c. comp,under the crank pulley,on the inside of water pump, and around tensioner pulley.
