P0016 - Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
symptoms
The engine may turn over but not start up
The engine may rattle near the harmonic balancer which means that the tone ring is damaged
The engine may start up and run, but run rough
cause
Timing chain is stretched, or timing belt skipped a tooth because its worn
Timing belt/chain not aligned
Tone ring on the crankshaft slipped or broken
Tone ring on the camshaft slipped or broken
Faulty crank sensor
Faulty cam sensor
Bad wiring to crank or cam sensor
Timing belt or chain tensioner faulty
The fix
Check the cam and crank sensors and their wiring for damage. If you see broken/frayed wires, repair.
If you have a scope, check the cam and crank patterns. If a pattern is missing, suspect a bad sensor or a slipping tone ring.
Remove the cam gear and crankshaft balancer and tone rings for proper alignment, make sure they're not loose or broken and they haven't sheared the alignment key. If they are correctly installed, replace the sensor. If the signal looks normal, then check the timing chain/belt for proper alignment. If it's not aligned, check for a damaged tensioner.
Also check that the belt or chain isn't stretched. replace and recheck.
Trouble code P0016 means: Crankshaft position/camshaft position, bank 1, sensor A- correlation
With a water hose -Old school
where is the thermostat located on the dodge intrepid 2004
how to replace a map sensor on a 2004 dodge intrepid.
You will get error code P0016. And you will hear engine knock.
No.
No, a spoiler for a 2004 Dodge Intrepid will not drop the gas mileage.
Intrepid Journeys 2 - 2004 is rated/received certificates of: New Zealand:PG
The 3.5 litre V6 engine in a 2004 Dodge Intrepid has a timing BELT
Yes, 2nd Generation Intrepid was made from 1999 through 2004 IDENTICAL Cars Actually, it was 1998 through 2004.
2.7l is about $1000 to $1500 3.5 about $450 - $550 with a 2.7 the water pump is in the motor
No
5w30