0
That means the switch is Normally Closed (NC). You press an NC switch to break the flow of current.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Is the pressure switch high Normally open or normally close?
A pressure switch can be normally open or normally closed. It depends on how it was made. The NO/NC should be marked somewhere on the switch. A pressure switch can be normally open or normally closed. It depends on how it was made. The NO/NC should be marked somewhere on the switch.
What is the difference between shown in drawing and shown on drawing?
Shown in drawing and shown on drawing can mean the same thing. These statements would both indicate that the concept is shown somewhere within the drawing.
Where does the neutral wire go on a single pole switch?
Unless the switch has a light to indicate the switch is turned on, there is no neutral connection to a single pole switch.
Can you use a pnp as nc switch which legs connect to what to open switch?
Look at this link http://www.rason.org/Projects/transwit/transwit.htm
Is there a Chase Bank in Wilmington NC?
unfortunately the only Chase Bank is 2 h away. I moved to Wilmington,NC, and have to switch banks as a result.
Which aspect of the Elizabethan society in which Shakespeare lived is shown in these two scenes?
You have to indicate what "these two scenes" are.
How do indicate a repeating decimal?
A repeating decimal is usually shown with a bar over the decimal that is repeated
Does the Nintendo Switch have a headphone jack?
Yes. It is shown in the video Nintendo released.
Which components on a power liftgate work together to indicate the position of a power liftgate latch?
The primary and secondary forkbolt switch with the detent switch.
Which wire will be connect at NO or NC contact?
NO stands for Normally Open and NC is Normally Closed. It references a switching application. It is the base state of the switch. So if the load is connected to the NC terminal it will usually be energized and when the switching device is activated the circuit will open and the load will be de-energized. The NO terminal would have the load de-energized until the switch was activated and then it would be energized.
What do you connect into your circuit when it says NO NC and Com?
A: NC stand for normally closed and COM stands for a common switch point the other term is NO for normally open it applies mostly to relays
How does the syst led on the catalyst 2960 switch indicate a post failure?
A steady amber LED.
