It may be a bulliten issue. It is a problem with the fuel level sensor. The bulliten states: 18465 1997-2005 MULTIPLE VEHICLES - INTERMITTENT MIL ON WITH DTC P0460 - SERVICE TIP
SOME 1997-2005 VEHICLES MAY EXHIBIT AN INTERMITTENT MALFUNCTION INDICATOR LAMP (MIL) ON WITH DTC P0460 (FUEL LEVEL SENSOR CIRCUIT MALFUNCTION). THIS CONDITION MAY BE CAUSED BY AN IMPROPERLY INSTALLED REMOTE START SYSTEM, AFFECTING THE FLUID LEVEL INPUT (FLI) INFORMATION TO THE PCM. THE CONDITION MAY BE DIFFICULT TO DUPLICATE. TO SERVICE, CHECK FOR AN IMPROPERLY INSTALLED FORD OR AFTERMARKET REMOTE STARTER SYSTEM. THE INSTRUMENT CLUSTER OR HEC MUST HAVE POWER TO ALL 'HOT IN RUN' CIRCUITS FOR THE FUEL GAUGE CIRCUIT TO PROPERLY RELAY FLI INFORMATION TO THE PCM (EITHER BY NETWORK COMMUNICATION OR A DIRECT HARDWIRE CIRCUIT).
EFFECTIVE DATE: 03/11/2005
( P0460 ) - Fuel level sensor circuit malfunction
The P0442 warning code in your Ford Escape is indication that one of the oxygen sensors is malfunctioning. There is a total of four oxygen sensors.
Trouble code P0780 means: Shift malfunction
"EGR Vacuum Regulator Solenoid Circuit" is the "official" OBDII definition. What this means specifically to your vehicle will require some research on your part.
This is not a "Generic" OBDII code. That means that it means diferent things on diferent car makes.
I believe that means you have a problem in the fuel level sensor. Usually reads low gas in tank when it's actually not
It is the oxygen sensor, if you need to find out what a code means go to obdII codes.com
trouble code P0420 means: Catalyst Efficiency Low - A Bank
Trouble code P0128 means: ECT Sensor Below Thermostat Regulating Temperature
This code means Theres an EVAP Purge Flow fault.. hope that helps
Trouble code P0411 means: Secondary Air Injection Incorrect Upstream Flow Detected
Code P1000 means that not all the OBDII monitors are complete. That means the engine control system has not finished checking itself after clearing codes or disconnecting the battery.