Short Answer: Try to get speakers with an RMS wattage rating roughly equal to the RMS wattage rating of the amplifier (per channel). Further Information: If you amplifier puts out 75 W RMS per channel, get a speaker that can handle 75 W RMS. If you get a speaker that handles 150 W RMS per channel, you will find that the amplifier doesn't have the power to make it sound as good as it could / should. Also, lower frequencies (where the amplifiers wattage rating is put to test) could burn out your amplifier. The opposite is also true. If the speaker can only handle 25 W RMS and you hook it up to a 100W RMS amp the amp might send so much current through the speaker coil that the coil wires heat up, burn off their coating and short together. This, in my opinion, is much less likely to happen though. NOTE: An amplifier doesn't put out its rated wattage all the time. The amount of wattage dissipated by the speaker varies directly and greatly with the music. A flute solo for instance being played with a huge 1000 W RMS amplifier might just put out 20 W RMS during the solo. But when the big organ kicks in jumps to over 900 W RMS.
1600 watt amp. your power amp should 2x the rms value. To varify, check JBL's website and look in one of their speaker manuals, it will show you their speaker wattage and then show you the recommended power amp wattage.
RMS is the average power that the speaker will take
it would depend on what brand and what size sub it is i would recommend 250 watts
for Two* 17 inch subs? Assuming this is what you mean, your question is still completely unanswerable. All you have to do when getting an amp is basically to match up the RMS Wattage on the Subwoofers to the RMS Wattage output on the amp. Impedance will factor into this as well.
Each speaker is rated at 200 watts rms
an amp with 300 or less rms wattage output and 1000 or less peak wattage output.
Wattage is the amount of sound a speaker can pump out. More wattage means the speaker will be louder, but won't necessarily sound better.
I'm guessing your talking car audio, and you mean the speakers have a higher wattage rating than your stereo output. its a good idea not to underpower speakers too much. the sound will be distorted, and you could possible damage the speakers. there are two ratings of wattage for speakers and amps. RMS and Peak watts. always build your system using the RMS wattage. its is the real wattage. the peak is only usefull in the labratory its built in. RMS is is constant ability to put out, or receive that power all the time. The impedence (ohm value) of the speakers is important, it should be the same as the amp.
Rms is watts that's the amount of watts a speaker is rated for.
Yes unless you want to smoke your subs
low like 15 rms 30 peak per speaker aftermarkets start at 50 rms per speaker