Want this question answered?
A fan or cooler relay is used in electrical furnace to change the blower speed to the blank speed for cooling
low
increase the efficiency of the system
It could have any size heating furnace, the two are unrelated except for the size blower used in the furnace to support the 3 ton cooling system. But the fact remains you can get a 3 ton blower in 50,000 btu furnace, a 100,00 btu furnace and anything in between.
Bad low limit switch,fan switch.
There should be only one blower to move the air. The unit will have a coil for cooling and a heat exchanger.
Need to know what type of furnace, electric, gas, or oil before question can be answered.
If you have a 2 stage furnace (hi fire & lo fire) then the blower will run on lo speed in lo fire & hi speed in hi fire and in AC mode. If it`s a single stage furnace lo speed for heat and hi speed for cooling.
It depends on the rating of the furnace. There should be a plate or sticker somewhere on the furnace that shows the rating. If you are just powering a blower motor the rating will be lower than if you have an electric heating element.
Watts
no
Yes it is. It contains the blower.